Search results

I just purchased a used 3point hitch wood chipper for my BX23s . Am I missing something or can I not leave the tractor seat with the wood chipper PTO engaged. I know I can start the trac5or while not seated if the parking brake is engaged but it dosen't seem to be the case with the pto. Is the...

I have swapped the front end loader from my B8200 manual to my B8200 HST including the entire sub frame. I am now reassembling my Bradco 8LD back hoe that has been in pieces for perhaps four years in preparation for all new hoses and some pivot pins, bushings and a cylinder rebuild. I would...

I have a chance to buy a good used Ford dirt scoop from a family member. It is too big to fit on their Mitsubishi 180 (970 cm) width and I was wondering if it would fit my B8200 (1400cm)width. Has anyone used one of these implements on a similar sized tractor?

I went to put away my B8200 for the winter. It is one of two I have and the one I'm dealing with is my parts tractor. It runs fine but has been idle for the summer. I hadn't noticed that I had parked it under a roof overhang and water had entered the exposed exhaust pipe. There is a lot of water...

I recently swapped the hydraulics from my B8200 manual to a B8200 HST. The FEL is functioning fine and I am about to reassemble my Bradco 8LD back hoe. The backhoe has all new lines and is ready to be reassembled after having been in pieces for a couple of years now. I would like to no the...

I am presently swapping my BF 300A FEL from my B8200 onto my B8200 HST. All the sub frame has been installed but prior to the install I would like to purge the FEL of old contaminated fluid before introducing it to the HST. What is the preferred method to drain the old fluid? The B8200 HST only...

Hi. I am taking my B8200 manual and swapping my loader and Back hoe frame including all hydraulics to my recently acquired B8200 HST that had been used only for mowing. Should I expect any surprises or will everything be fairly straight forward?. Will the mid PTO have to be abandoned on the HST...

I purchased a second B8200 that came with the belly mower and I don't need it. It is in decent shape with a new belt but missing the covers. I will include all hardware. $600 . I am in Georgian Bay area of Ontario, Canada https://photos.app.goo.gl/SaR5ma6zFrkUhYvC6

Hey guys. I had a catastrophic break down of my front axle on my B8200 non hydrostat and after much searching and disappointment I have secured a B8200 HST as a donor tractor. The former has a front end loader and a Bradco 8LD back hoe with the frame undercarriage. The HST has a belly mower and...

I am in need of an entire front unit as mine is in total need of a rebuild including ring and pinion gear assemble and most bearings and seals. Anyone have any ideas where I could find one? I would even consider buying a complete tractor for parts.

I am rebuilding my front axle and am having trouble separating the front axle arm from the Bevel gear case. Does anyone have a solution that doesn't involve wailing on it?

Hi. I am new to this forum although no stranger to it. I have recently purchased BX23S and I am considering buying a Bolens 48" 3pt. hitch snow blower. It's not pretty but the price is right and it is in good repair including a hydraulic chute. My question is this.Is this blower in need of more...