Search results

I found a small diameter cable right at the back (under rear of dump box, right side) that is not connected to anything...hour glass shaped cable end with a 1/16" hole. Very cramped under there to see where it should go...anyone? Thanks

When my pump seized it did so in a position that made it very difficult to remove, I removed this adjustment screw to help get it out (didn''t help), and would like to know how to set it properly now that it's back together. It runs fine, but doesn't like going uphill. Have read about adjusting...

Hi All, Recurring problem of starter not engaging, can the dump box be lifted without the engine running? Usually a few clicks will get it going but not this time. Can the box be lifted with a come-a-long from the roll bar to service the starter (again)? Thanks, Seann

Finally got the pump out, had it repaired, back in working again. Photos show the problem. Centre spring broken, one rusty plunger. May have been a bit of a problem since I got this several years ago, it always smoked quite a bit on start up, doesn't do that any more. One question...I took the...

I've determined that the rack is stuck in my pump (no fuel getting to injectors), is there a link to procedure for pump removal? I have removed fuel lines, intake manifold and cut solenoid (working)...anything else I should be aware of before lifting pump? Thanks, Seann

Hi Folks, Just out of storage yesterday, drove around for 1/2 hour, pulled in to park it and while creeping to a stop the engine started revving high (still in forward but not moving), turning key off made no difference. It revved away for about a minute then slowly died, wouldn't re-start. Any...

Hi Folks, Tried to start RTV today after winter storage, battery is right up, starter spins but won't turn engine over...like an old fashioned starter that needs a good whack! Is there an override to lift dump box without hydraulics/engine running? Thanks, Seann

Hi Folks, Where is the glow plug controller on an RTV 1140, and what is the part number? Don't see anything under dash...no power at plugs, no lamp, getting hard to start cold. Would like to test controller & relay, bulb is good. Thanks

Looking at purchasing a B6200 in great shape, only one concern. The lever to engage 4wd is VERY difficult to push into position. Don't like the idea of "force" when it comes to operating any equipment. Any ideas for cause? Common problem? Also, how do these tractors handle blowing snow on turf...