Search results

4 cylinder sleeves, rod and crank bearings, valve guides, valves. Not everything needed for rebuild. Located near Philadelphia. $150 plus shipping

Would someone post a picture of the bracket that the support rod connects. Shown as “a” in diagram

I am hoping someone has removed this backhoe previously. The L5412 is 20years old and cannot find any manual for it. I have done the traditional Maneuvers to loosen the connections but cannot remove the T- pins shown in pic.

For Kubota B8200 Fuel tank $50 Grab handles $25 Ignition Switch $25 Hydraulic mesh filter $10 For Kubota L3750 Ignition switch $25 Plastics for dashboard $100 3pt arms $300 Backhoe Subframe $450 fits L50 series tractor. Fits L5412 backhoe and others Located near Exton Pa Shipping extra

Has anyone removed the hydraulic tank from a L4540 backhoe? This is not the A-series. The 4540 implement is used on l3650 and L4150. Parts diagram does not show how it is bolted to the frame.

Comes with extra bucket. No leaks and some hoses replaced. Controller has quick connects. Subframe off L3800 but should fit series to L4200. Located Exton Pa. $3000

Re-assembling L3350. Had the crankshaft main and rod journals machined. Rods machined .4 mm and mains to .2mm. Used assembly lube. I doubled checked the oil clearance and it’s in spec on the tight. Side. I could turn the crank by hand. However when I installed the rods/pistons and torqued to...

Kubota l3600-4200 Hood $100 Side panel $150 Lift arms $300 Prices are plus shipping

Replacing pistons in V1902 engine out of a L3350. Using plastic-gauge I find one crank journal to connecting rod bearing to be almost twice the WSM spec (.003. VS .006). I find specs for minimum clearance but not maximum limit. The crank is still in the engine and I just pulled the oil pan...

I need to replace piston/rings without separating the tractor. I am thinking that someone has removed the oil pan and replaced pistons. I have done this on other L series tractors but this appears challenging. To start the oil pan weighs about 54 pounds which will require a lift/jack. It...

Need help for attaching arms to support loader. I have a set of two arms but cannot determine where or how they attach to loader. Appears BF800 support arms are different from other L series tractor. BTW tractor is L3350

Major components: Good 40 hp ENGINE, 4 cylinder V2203, new head/high compression, complete with hydraulic/injector pumps, alternator, etc, Complete GLIDE SHIFT TRANS, Hydraulic steering, 3 pt controller, ROPS, Front LOADER LA 680 and subframe, hood and side panel sheet metal, lots of miscelleous...

Would like to buy LA843 or LA854

What manufacturer produces red/rose colored hydraulic fluid?

Going to sell soon as I can split it from engine. No price yet. If interested PM me. Located near Philadelphia

I purchased A L 4330 which had experienced and over heating and a frozen engine. The heater hose had ruptured which led to a failed head gasket with antifreeze on top of one cylinder. I am having the head magna fluxed and a valve job. After removing the head I noticed that on one of the cylinder...

I see lots of wanted ads for this front end loader. Hopefully someone knows where one is available for L4310

Does the side level on the pump controls the amount of fuel or is it only off and on? If I tie the lever to the shut off lever will it still work?

I need the top component but will buy entire rops. Let me know what you have

Looking for the front roof assembly which is the upper part of the front grill. Part# 32539-18100 Grill from other large L-Series may be made to work. Let me know what you have.