Search results

I pulled off the plastic and cut 3"s off. Replaced the plastic 👍

That made my day.:D

Sounds famiilar. Check this to see if it happened to you. https://www.orangetractortalks.com/forums/showthread.php?t=46069

My L3901 left me stranded when it would not restart on a dirt road. Could hear the fuel pump engage and had no Codes displayed. Checked the seat switch and all levers for correct positioning along withe switch. No issues found. Fuses were checked with a multimeter and Fuse 6 Starter relay had no...

I had the same problem with attachments I wanted no up or down play. So I fabbed up this tool I could install when needed to prevent that. Don't mind that I used a 3-point to reciever adapter I made. It was already on the QH.

I fabed this up to accomindate my size 13s. Also makes it easier to use reverse by just hooking the toe underneath.

Used my GS1560 Grading Scraper to gather fallen oak leaves into a pile. Works well when set to just scrub the grass. As it fills with leaves it works even better.

Been there did that:( My tool of destruction was an electric HD Milwaukie 1/2" drive impact.

Got to admit this pissed me off. During my thirty years in the Navy as a Missile Technician on a Sub, it was ingrained into me to read and follow proceedure. I knew no other way. You just do not want mistakes with what I worked on. With the 3350 I had with its issues, I read and reread the...

I adapted a 12vdc bilge evacuation fan and a 90° elbow.

Vaseline has always been used on my battery terminals. https://itstillruns.com/inexpensive-prevent-battery-terminal-corrosion-5770493.html

I looked at the weld that failed, it was crap:eek: More like it was tack welded and never finished. Other side was fully welded on both sides. The one that failed was only on one side and it was a small bead.

I went another route as I did not have the time to repair. Made this from stuff laying around to use on the 3point receiver. (just be careful......right;) )

Yepper, blew right past that:rolleyes:. Did not consult specs in the heat of the moment. Now looking for a correct one.

And that second pic is next to the said scrap pile. :D

This is totally my fault. Back when I bought the BX1850 I got this CountyLine subsoiler which I modified for trenching and cut through roots. Today I needed to dig a trench and put it on the current tractor an L3901. 1850 would stop on a stump....Not the L3901.

;););););););););)

I got that code also this morning. First start-up with the temp around 37°. After letting the glowplug light do its thing started then bogged momentarily causing the engine light and the code. Engine light went out on a restart but code remained. Spoke with my dealer's Service head and said it...

https://www.orangetractortalks.com/forums/showthread.php?p=355295#post355295

I have a GS1560 I pull with my L3901. I went with the 60" as I only wanted one slightly wider than the tractor. The set up the blades I on it to stick out about ¼" below the skid plate. This how I set up the orientation for different surfaces. Dirt-unimproved I start with the rear blade lower...