Search results

Thanks to all. Yes, you were right, I had reinstalled the drive shaft out of phase (never heard of it before). It was an easy fix once I understood the problem and all is well now. You guys are stars...thanks.

thanks. The shaft connects to the front axle, the splined front end is covered in a plastic boot. I will search the forum...

Sorry! I guess these terms are from the other side of the Atlantic To you! Graunching is a noise like gear wheels crunching, as if you try to change gear in a manual car without using the clutch. To move off is to start moving , or accelerate from stationary.

Hi All I lost the 4 wheeel drive on my Kubota a few days ago , because the splined shaft connecting to the front axle had come adrift. I cleaned it up, reconnected it, and the front wheels do now drive when the 4WD is engaged, but with a very rough feel, almost graunching, when you move off. Do...

Thanks to both...it was the PTO interlock...a bit of the wiring was wedged in front of the interlock, keeping it on. Easily fixed...

Hi All I discovered a week or so ago that the HST cooling fan had become disconnected from the flange on the con rod, and was just waving in the breeze. The bolts holding it on had come out. So, with help from various forum posts, I refixed it, had to hoist the engine up and forward a little...

Thanks a lot Joe, I will try that. Is there a separate lever for the three point linkage tho'? Otherwise, when I push the right hand hydraulic control lever down, both the under chassis arms (on the mid mower deck) and the rear arms will lower...? (that is when I get the speed control valve...

Hi All I have just bought a 10 year old BX2350, which the previous owner had just used for grass cutting (middle deck). No manuals, but I have downloaded some. He had a GCD 600 BX grass collector which I have taken off in order to use the 3 point linkage. Problem is, I can't lower the hydraulic...

Thanks....any idea where I could find a diagram of the B2100 hydraulics? The local dealer went bust a while ago. Peter

Re: Side shift mower on B 2100 HST Sorry...slip of the finger....B2100. Thanks for information. There is a grey plate to the right of the 3 point linkage...see picture below...not sure if this is covering an auxiliary hydraulic point? Thanks again Peter

Side shift mower on B 2300 HST. Whoops...B2100 Hi All I need to fit additional hydraulic ports and control valve on to my Kubota to control a hydraulic top link and also a side shift on the mower hanging off the three point linkage. Does anyone one know if the tractor has an "open" or "closed"...