Search results

A couple late after work days built this one for my 50hp. Sent from my iPhone using Tapatalk

New to me L35, leaking hydraulic line on the hoe, goes under the boom lower pin. it's the upper far right line on the top if looking and seated on the seat. any advise on what this line controls before i dig into it to replace. Sent from my iPhone using Tapatalk

need to get L35 shipped from 03070 to 35476 zip. Where do i start? Sent from my iPhone using Tapatalk

BT 900 Backhoe for L35 Bought a backhoe to fit a Kubota L35 TLB! I can stop looking now.

Anyone know the size bolt and thread type for the larger bolts that hold front plate, brush guard on the L series kubota tractor frame? I do not have a metric bolt that will fit correctly.

Replaced the mismatched front tires with two very lightly used goodyear R1 in the next size up. Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Well, kubota headlight assembly 120 bucks, naw... 1/8 plate, mig welder, LED light bar, some dull drill bits, two cuss words, pair of rubber washers and walla Sent from my iPhone using Tapatalk

what is a D722 with 60 hours on it with radiator and muffler still attached? complete and running. Sent from my iPhone using Tapatalk

I tried to see how low the dipstick goes into the oil pan. With the pan off, it looks like the oil level at the full mark is above the pan/block gasket level? Does the oil level usually ride above the pan gasket level? or should the oil level be below the gasket?

Well i got this old bucket of bolts apart tonight. Looks like it made quite the commotion when it came apart. Hoping to save the crank but... These parts were in the pan. I'm trying to put the story together... Was told it started knocking on a uphill pull, stuck supposedly... Anyway, the...

coming right along now. made this exhaust straight with flapper. hope the neighbors like it! alternator mounting hole to be increased in diameter or a bushing and the existing hole with smaller bolt, not clear what's best yet. next is wire the switch... i got an new kubota switch for older...

Anyone know where to find the wiring harness plug that plugs into the three wire plug on the stop solenoid? I need the end that would come from the dash wiring harness. Sent from my iPhone using Tapatalk

IDI v2203 E from a carrier reefer unit. I'm getting ready to fire it up. what do I do with the three wires from the stop/run solenoid, they are red white and black. I read where the white goes to a white wire on the starter, red to 12v ign switched and black to ground. Is this correct? Because I...

I'm building a generator set for the house using a v2203 engine, I need a radiator idea. primarily cheaper options other than eBay new radiators. what else might fit? pipe sizes? etc. any help is much appreciated.

any idea how to find the rear tool box part number? L3600, my tool box behind the seat is rusted out, do I try to cut out all the bad and tack in new flat pieces or replace? any idea on a part number, I looked on messicks site but no picture of what I was looking for could be found. any help is...

V2203 with flywheel and bell housing removed, what are steps to ensure TDC on number 1 cylinder to start valve lash check and adjustment? Any pics? I have the WSM but I'm not exactly following the steps since they have you look at the flywheel peep hole.

Anyone know where to find a line up tool for this input shaft? Maybe a part number or eBay item number? It's for a L3600.

Wolfman you hit this one out of the park. Bellhousing you sent me a link to is a fit.

Split the kubota this afternoon, dolly i fabricated worked out perfect. rolled the front end straight away. no issues.