Search results

It has a bit of a triangle shape to it from the top down view. It's the black receiver piece for a front mount snowblower. It's number 20 in this diagram.

Looking for a good condition receiver mount for BX2750D snowblower.

Thanks! This is exactly what I was looking for.

Anyone replace just the boots on the tie rods? They look like generic boots, I'm just unsure of the size and haven't had a chance to measure mine yet. The joints on mine are perfectly fine and still tight, the boots are just ripped. Example picture of what I have on my BX2200.

Haven't gotten that far yet :)

I'm going to buy a lever similar to the others in the other slots and attach it to the valve. That way it looks the same but controls what I want.

I'm thinking of putting a two way valve there that connects to the main hydraulic lines for the FEL, then run it to the front for the blower. I'm not going to connect any levers to the gear box or existing valve if that's what you were wondering.

If it's not used then I might retro fit that slot to control the cylinder on the snowblower instead of using the 4-way valve for the FEL since the valve comes off with the FEL. Thanks everyone!

I'm wondering what the missing lever is in the attached picture. It almost looks like it'd operate the snowblower raise/lower cylinder, but I don't see any hook ups for that cylinder other than the ones used for the FEL. I'm also not finding any diagrams that label it correctly. The manual I...

Looking for the bagging system for the gas TG1860G lawn mower. Doesn't need to have the pulley/vacuum system, but prefer it to be complete.

Update again. Straightened the lever arms and welded some reinforcing bar to stop it from twisting. Belts still smell a little burned every now and then depending on the angle of the blower relative to the tractor. The higher the blower is the more angle there is on the belt, causing the...

Thank you! That's exactly what I needed!

My throttle cable broke a couple inches off on the lever side. Messicks doesn't list a part for TG1860G mower. Does anyone know the party number? Or the length if I can find a generic one? I'm missing an inch or two so I could probably estimate it but would hate to be wrong and have to buy two.

Following up for posterity. Took everyone off getting it ready for mowing season, noticed one of the lifting arms (the short ones connected to the large lever) was bent compared to the other. I noticed it always sat on the ground with a "high side" that didn't seem to put all its weight down...

The shaft/pulley doesn't wobble when running, and is still really tight. When I put the quick attach on everything was still solid so I think it's an alignment thing outside of the pulley, like the lever arms or something.

Here's the pulley. It does in fact have a long side, but I'm thinking the bottom might need to be that far down to clear the frame for the front wheels. I might need to track down a diagram to see what the correct orientation is.

That's a possibility for the snowblower side. I haven't replaced that belt in the two years I've owned it. I might take that one off and measure it.

Looking over all of the attachment points, I don't think there is anything to adjust. Only thing I can think of is something got damaged. The raise/lower arms can't move forward to correct the belt alignment due to the holes the pins go in, and the quick attach can't move back any farther...

I'll have to take a look at it to see if any of the brackets or mounting points are bent. I know the plate arm things that connect the quick attack to the raise/lower arms of the mower are undamaged, but there may be others I haven't noticed. Unfortunately I can't find any diagrams that show...

Do you have a picture of the holes you're referring to? I don't see another set of mounting holes that could change the geometry to align the belts. I'm wondering if I'm maybe missing some brackets or something.