Search results

ANSERED MY OWEN QUESTION /Rod out fuel off.

L3130 When the fuel solonid actuator rod is in the out or extended position is fuel "ON" or "OFF" to the injector pump ??? Thanks

L3130 can you install a fuel shut off cable to over ride fuel solenoid. / Having electrical problems. / Need to use tractor. / Have changed "ALL" switches , OPC timer , Starter Relay , ignition switch & the fuel shutoff solenoid.

No still shutting down fuel solonid clicking in & out

Put every thing back to OEM engine still no crank / jumped the starter tractor runs & operates as normal /turns on &off with switch. just will not crank with key switch. / starter relay ??

Thanks for the input & yes to all the above. Before this no cranking issue the fuel solenoid would shut the engine off with now one on it just sitting there idling. ( it is a new solenoid ) changed it when this first started FYI

wired the solenoid back to OEM have dash lights power to solenoid (it cilkes when ig is turned on / have power on all 3 poles out of ig switch when switch is in start position / there is only wire to starter it hase no power when ig is turned to start position / how do you jump these starters...

Hot wided the fuel solnoid started right up turned tractor off now will not even crankover HELP

Ok hot wired the solenoid works fine . Ignition switch . (Maybe) Wiring diagram power comes from ignition switch will get a new one & replace.

Changed the solenoid the orinal one was clicking on & off ( you could hear it ) The new one is doing the same thing " but not all the time used the tractor for a hr plus yesterday no Problum .Today used it 10 min. earlyer today no Problum went to use it agen "Problum" solenoid clicking on & off...

shuts right off. If you just unplug the fuel shutoff will it start or do you start it then unplug?

L3130 Starts right up runs min. Some times two will shut off let sit 30 sec. or so will start right up (no black smoke) Have not had Problem while operating. Have let it run at idle & 1/2 throttle not moving & will shut off. Dose not happen all the time.

Run a 72" behind my 1952 ferguson TO 20 there only 20HP can mowe in third gear 2nd if grass is high your 2650 will do fine

Put a plug in one on my 2018 GMC 1500 maybe 6 months now works fine. Is a band-aid yes butt the best price for a cam & lifter change kit is over a $1000 bucks. From all I have looked up the little pin in the lifters is "NOT" engaged when "NOT" in AFM mode so my simple mind thinks if the pin is...

THANKS

THANKS

How many gallons of hyd. oil do i need to drain just to do a Filter Change ? Will save & reuse (Exp. $$ UDT OIL ) THANKS

More time than money

i would bleed injector lines. messy job big pan under engine. i would start at the injector pump & then to the injectors. my 2 cents. And 13k is crazy. Worst case need to by a remand injector pump & injectors.

I know i have hearing loss. But i like to hear whats going on running my equipment. Just my 2 cents.