Search results

Thanks bxr. Do you cut a table saw cerf down the center? and then stick it on the sharp edge?

Thanks mcmxi. I could if I have too leave 6 inches of snow. That way leave the stones alone.

Thanks mikester. I have a B7800. 30 hp 4 cy. I'm thinking back when the last time I used it. When I lift up the back it goes strait up. I don't think I could tilt it to a different angle. I could be wrong. If I go over there with it, I would have to buy or rent a trailer. Two axel I think.

I have a frontier snow blower on the back of my kubota. I have a friend with a crushed stone driveway. Very manicured lawn. I have seen people move snow of it with a plow. Makes a mess. stones all over the lawn. I was thinking of trying to keep my blower 2 or 3 inches off the stone. and don't...

She has quite a smile.

Those would be great if I had a crushed stone driveway. But I have blacktop. I heard those are not good for blacktop. I wonder if the ones im thinking of are bad on driveways too. Thanks.

not studded chains, just studs. Since the b7800 and some other models don't have enough clearance in one spot on the fender I think. A chain can rub. So they use a spacer. I don't understand how. I see one spot on the fender that has a couple of bolts that could rub if the chain was kind of...

How about putting on studs? Can you take them off and on? I have them on my truck tires. Any thoughts? Thank you.

Thanks SDT. Mine were ladder type too. I sent them pictures. Didn't hear from them. I bought them through amazon. I sent them back. I was short about 2 or 3 cross chains. the side chains were about 6" too short.

I bought a pair online. Tire chains.com 12.4-16 they didn't fit too short. I have Industrial tires, and they are filled with rim quard, if that makes any difference. Kubota B7800. Thanks.

All that typing winds up being for nothing. Because the site says you must first be logged in to post to the forum. But I was logged in. What gives? filix

Sorry. I wanted to say more. But my computer is acting up. I already saw that video. It helped. I put my tape from inside to inside of both PTO shafts while the implement was on the cement floor. 26/1/2 inches. The drive shaft is off. way too long to put on. When i pull the drive shaft appart...

Hello . I have a b7800. I bought a fronteir sb1164 snow thrower for the rear. Im in the middle of puting it on. I messured between the shaft of my tractor and the shaft on my snow blower. "with the snow blower on" its 26.50'

I saw a king cutter 6' I dont know what he asking. I have alot of small branches, pine cones, leaves to pick up. I thought I could drag the stuff is the woods. Thanks.

So I think i'm going to look seriously at frontier mad by Rad. the sb1164 but in kubota orange. I wounder if I could order one from my kubota dealer. Or go used?

210 degrees would certainly be an improvement over 180. Would probably would work. My place is pretty flat. Thanks.

Thanks everybody for the responces. I'm not totally sold on the back one. But I was looking at the 64" sbt 064 by everything attachments. One huge advantage with this one for me would be that the chute rotates 360 degrees. I have a very hard spot . my front walkway is about ten feet wide and...