Search results

Got the new brakes shoes but the brakes still did not work. After taking it apart again it appear that the linkage is not factory. So at one point someone replaced the linkage but made the rods to long. I cut about a 1/2 inch off of each rod and now the brakes work. How long should the...

Thanks! Ordering new ones with the springs https://southern-global.com/shop/transmission-rear-axle/brake-kit-bk-k34150/ . Do you know if anyone in the midwest will reline them? What is normally the cost to have them relined?

drum is 5.67". How do you tell the upper and lower shoe apart? They both look exactly the same to me.

How do you even measure them? What do they start with in the first place?

So I put everything back together after replacing the seals on both side. One side you have to apply the brakes about half before they start working the other side does not work at all. I have turned the adjustment as far as it will go but I still have no brakes on the one side. Am I doing...

At one point the l225 had a power steering kit. There is an old forum with a kit that could be purchased. https://www.orangetractortalks.com/forums/threads/power-steering-conversion.6543/ It sounds like the person who used to make them passed away a few years ago. Would a power steering kit...

Also I tried everything on the bolts that you see are broken off. Heating with torch and trying a reverse bit to break them loose. Nothing worked so I drilled out the holes. and will use a lock washer and new bolts.

Just had to hammer and pry on the end of the plate with a crow bar. It slowly came loose.

I added some pictures. I don't see any snap ring holding it in

Hi everyone, Working on my Kubota L225 brakes. I removed the cover, brake drum, and pads without a problem. The cover was attached with RTV red gasket and only a few 8mm bolts. The problem is that the cover should have been attached with about 10 bolts the rest have been broken off on the...

I am just going to remove all the back hydraulic extra's on the tractor and put a plug where that comes out from the 3pt. Does anyone know if this plug is anything special? The part number needed is Kubota 34150-27590 and Kubota 04714-00300 for the gasket. Could I just get a metric bolt to go...

Also trying to figure out what some of the hydraulic hoses should go to. Here are some pictures.

It is not difficult to remove the loader. Problem is the power beyond unit is welded directly on the loader and not the loader frame. It looks like I can weld a new support directly on the loader frame and then attach quick disconnects to bottom 4 connections to the loader. Replace the loader...

I have a 1976 L225 Kubota with a loader attached. Is there a way to replace the hydraulic hoses and add quick disconnect connectors so I can take off the loader when not using it? It needs many of the hydraulic hoses replaced anyways. Do you think the tractor pressure would support the...