Search results

Thanks Rodger.....good information.

Got it...Great-Thank You

Thanks for the good information. I am replacing the seals and 0 rings for the delivery valves as I think all 3 are leaking. Do you know when I am done how do I know the proper tightness for the delivery valve holder??

The owners manual for B8200 says to open bleeding screws on top of fuel filter two turns until bubbles disappear then tighten. Then open open the air vent plug on the fuel injection pump and turn engine (with stop button pulled) for about 10 seconds. Close the air vent when air bubbles...

Thanks Wolfman for the info and I follow what you are saying. I think I might try to give it a shot as those parts are available at the local kubota tractor dealer. You mentioned to tighten the Delivery Holder to spec in the WSM (service manual). Can you tell me what that is as I do not have...

Thanks guys. I'll let it where it is.

I have a fuel leak where the three fuel line adapters connect to the top of fuel injector pump on my Kubota B8200. I tried to tighten the fuel line nuts above the adapters and none seemed loose. However this must have disturbed the adapters below and I can now see the adapters connected to the...

In bought a used Kubota B8200 diesel tractor and the engine idles at about 1,000 rpm's. Engine model is D950-A-DT. Is that about the right rpm's or should it be lower? Can't find any mention of it in the owners manual. Also trying the figure out the year this tractor was made. The...

Thanks for your response. The pulley will lift off the spindle but the feather key keeps holding it in place. The feather key is entered into the spindle and recessed into the pulley with only the very top exposed. Can't get on it with a side cutter or pry it out with a thin screwdriver. Any...

I need to replace bearings on the right spindle. I have the top nut, lock washer and regular washer removed but the pulley will not lift out as it is held in by a feather key. How do you remove this feather key?