Search results

Some help on tracking down issues on my Dad's L2900. I see the connector to the air filter. The front grill has been off, but I've got the lights. I can't seem to locate the wiring that should plug into the air filter connector and especially the front lights. Where does the wiring typically run...

Any help, tips, or ideas on getting the internal snap ring out?

Previous post about getting the cylinder out. Now how to repair it. I have a 30ish-year-old L2900 and I've removed the steering cylinder as the seal was leaking. I was able to pick up all the seals at a local Kubota dealer. Any tips, tricks, or advice for pulling it apart and putting back...

Got both taken care of! Thanks for the help. A little banging with a hammer helped loosen the front support rust and it pulled right off. I had to "drift out" the rod end with a hammer from underneath to break the rust, and now it's all out!

Appreciate the help. Hoses disconnected and unbolted. The Rod end plate is removed, but the shaft is still in. Do I push or knock it upward to get it out? You can see the top of it in the picture. Also having difficulties getting the front support piece out. Are the bolts on the bottom and the...

Thanks. Looks to be a blown seal on the rear side/end of the cylinder (closest to the engine block).

Thanks for all this help. Replaced solenoid and worked. The cutoff cable/pull may also have been stuck some, along with the lever that it and the solenoid move. New solenoid and some lubricant and working great. Thanks for all the help and suggestions!

L2900 appears to be leaking hydraulic fluid from the front. In the first pic, leaking on the center of the front axle, from above. I think it's leaking from the part in the other photos. There is oil on the cross-member underneath it. Does anyone know what part this is (that has the shiny...

Thanks. I read in another post and depending on the model the solenoid works one way or the opposite fashion. Battery holding charge fine (only about 6 months old). All electrical seems to be working. Again, was using it just fine and shut off and wouldn't start back up.

No... and maybe this is tied to this issue or the other way around. For some time when turning the key off, the engine doesn't shut down. I have to use the engine stop knob (pull) to cut it off. Because it doesn't turn off with the key and I have to use the stop knob... is that a sign that the...

It had been running fine and just turned off. It tries to crank, but won't "fire up". I checked and cleaned the air cleaner, and it was good. I shut off the fuel and emptied the bowl and cleaned the filter with kerosine per the manual (The L2900 user manual states to clean it with Kerosine)...

OK, a little help. L2900. It's been running fine. Using it last week and the engine shut off. It'll turn over to crank but won't fire up. No odd lights or lack of lights (glow plugs, oil pressure, etc.). Changed out fuel to make sure not bad (but had been running on the current tank), cleaned...