Search results

And fixed..again! Seems I may have had 2 issues; the aforementioned water (which is still a maybe) and a plugged line out of the fuel tank. Tractor had been working great after replacing filters, and running some tank clean stuff in it, then started surging horribly again today. Disconnected the...

Worthy of its own thread I think.. After my recent fuel filter and water issues (which seems like a common problem throughout this forum) I ordered a filter relocation kit, with water separator, from Mike at botaproducts. Received it today, and I must say it appears quite thorough and well...

Fixed! Changed out the filters (after much cussing and swearing!) but it was still doing it, even worse now. Cleaned out Air filter, still doing it. Dumped in some tank/water cleaner, and after a few starts and stalls it was purring like a little orange kitten again. I did order a filter...

I didnt check the air filter, but good idea. I did check to see if it was the fuel cap not venting properly; just took it off while it was surging, didn't make a difference. I'll be changing both filters, and probably order a relocation kit with a separator as well, stock location for that first...

Hello everyone. Started having some surging/idling issues on relatively new BX23S (93 .2 hours). I'm assuming it's a fuel filter issue and have some on order. It starts losing rpm and damn near stalling, with no load. Only seems to happen once it warms up. Same fuel (from Shell) I run in my...

I've been trying to place rocks for a rock wall with my bx23s using the manual thumb while inventing new curse words. A hydraulic thumb would make this task, and others, so much simpler. I found one video where they installed a Kubota factory hyd thumb kit, part number BT1975, but its for a...

5x12 Quad trailer worked perfectly for bringing this old B7100 home

The clutch was adjusted as short as it would go. I reset it and lengthened so the clevis was about half way , worked okay for about 5 minutes and then she was done; had to rev the crap out it of and nudge it along with the bucket to move on flat ground.

Thanks. Clutch adjustment is first on the list. Just seemed so weird how it was seemingly working fine and then rather suddenly, nothing. That info sheet is handy. Based on my s/n it appears mine was made in 1980 and Asian market.

Howdy folks, I just picked a used B7100 4WD of unknown vintage (late 80's/early 90's?) and of course as soon as I get it home problems start showing up. After pushing around a bit of dirt while playing with it this morning, it seems to have lost power. The engine runs spectacularly well, I...