Search results

Anyone have experience removing the swing cylinder on a 4690 backhoe. It is attached by three-point hitch to a Kubota L3300. Thank you!

Anyone have experience replacing the fan belt on a Kubota M7060 tractor?

I have an 3300L Kubota with a 3-point hitch mounted 4690 Backhoe. I have had it since new (around 1998). The swing cylinder has a leak. DXoes anyone have any experience with the proper way to remove the swing cylinder? Thank you! Joe

Thanks for that in fo! I am hoping that my L3300 with the LA480 loader will lift a 4' x 5' round hay bale!

Thanks Dan. This tractor/loader is 24 years old. Does that make a difference in the spec?

What is the lift capacity of a Kubota L3300 with a LA480 FE Loader? Thank you! Joe

That is what I suspected as well. If I can reach it from the top of the tank maybe I can pull it out from the inside, otherwise i will have to drill it out from the outside. I should be able to find a plastic or brass nipple I can epoxy in there. Otherwise it is a whole new tank for $700 or...

Thank you for that information, very helpful! I did disconnect things and took the bottom support plate off. I put a jack under the tank to support it. The plastic nipple is broken off just outside the tank, about a quarter of an inch still showing, but I am unable to get a decent grip on it...

I ran over something with my M7060 and broke one of two rubber fuel line connectors into the bottom of the fuel tank. Can anyone tell me how this plastic connector is fixed into the fuel tank? Thank you! Joe

Thank you for the reply, I am going to check the timing module.

My L3300 will not stop when key is turned off. Replaced Stop Solenoid, same problem, checked fuses - seem OK. Any other suggestions?