Search results

  1. T

    Location of Safety Switches L3010

    I am trying to bring back my L3010 that was damaged by fire in transport. The fire damaged the left rear of tractor. I have most things squared away but it does not start (or even turn over). I did the obvious (battery and ground cable cleaned). I had a new key switch on hand and replaced it. My...
  2. T

    MX5100 Hood Problem

    My neighbor has a spotless MX5100F used only for mowing. He is frustrated with a hood problem. When he unlatches and lifts the hood, it always disengages from the "hinge bar". Then he needs a second person to help close the hood properly. To me, it seems that the gas struts that hold the hood up...
  3. T

    What bucket for a LA480 loader

    The bucket (L1750) on my LA480 loader, shall we say, has some character. The inside corners are rusted out, the top has a nice frown and a split but it is still useful. I may try to weld some plates on to keep it going. But, I have been thinking about replacing it--probably with a used one from...
  4. T

    L3710 Engine Speed

    This is not an increase the engine speed for more horsepower thread. (I found the dumpster fire threads when searching this topic.) I have a new to me L3710HST with 800 hrs. I just did the full 800 hr service. The PTO triangle on the instrument panel is at 2500 rpm (2475 per the WSM) but it...
  5. T

    Help with L3710 Leak

    I recently purchased a used L3710 HST to replace an L3010 that was totalled in tyransport when I moved. The 3710 had less than 800 hours it. It has a minor leak around the rear PTO area. There was a lot of load and caked dirt on the drawbar frame. I thought it might have been the PTO seal so I...
  6. T

    GR2100 Rear Axle Seal Leak

    The rear axle seals are leaking on my GR2100. It already had the Kubota transmission "upgrade" years ago when they had a recall. My question is about what parts to order. I see a transmission kit that includes the housing. Is this the same as the upgrade? If yes, then I already have the "new"...
  7. T

    L3010 Temperature Sending Unit location

    The temperature guage on my L3010 has always reads low. I ordered a new temperature sending unit with my last order of filters. I know my eye sight isn't what it used to be and my hands no longer fit easily into tight spaces but .... I can't figure out where it is installed, even with the WSM...
  8. T

    GR2100 PTO Kit Question

    I serviced my GR2100 for the start of mowing season earlier this summer. The hydraulic fluid was low so I topped it off. A week later, when I went to mow, I noticed fluid on the floor. I assumed that I overfilled a little. I also did not use a funnel when I topped and spilled a bit. This tractor...