Search results

  1. S

    Looking for Mower Deck G5200

    Great post and thank you. So newer model decks will work, with some fiddling. Is that what you are telling us? My mower has allot of hours, but is still strong. Does have a slight trans leak, but it is so slight I just top it off now and then, Thanks
  2. S

    G 52l0 Throttle Lever Removal

    will do, give me a day or two. Yes, 3700 hours and still running strong.
  3. S

    G 52l0 Throttle Lever Removal

    Finally got'er done. The fuel pump was indeed shot. So I adopted Bruce recommendation on an Edelbrock aftermarket pump. Clipped the plug on connector for the hot lead off old fuel pump, soldered to new pump, fab mounting plate and all working. Far less than $196.00 for replacement OEM pump...
  4. S

    Landpride Tiller Lateral Adjustment

    Turnbuckle operates as advertised with tiller off three point, will not turn with tiller (or weight) on. Had same issue when blade was attached, until I lifted weight by placing 2x4 under blade, which relieves weight of three point. Tried same on tiller, no soap anyway wen are operational, am...
  5. S

    Landpride Tiller Lateral Adjustment

    understand, all level now after taking tiller off. Just seemed to me one should be able to adjust turnbuckle with equipment on, guess not thanks for the post
  6. S

    Landpride Tiller Lateral Adjustment

    Done, adjusted fine, in good shape now and thanks
  7. S

    Landpride Tiller Lateral Adjustment

    only have one adjustment on right side. Yes I can post pic, but right side 1 inch at least higher than left side, Looked yesterday and maybe answer is to level lift arms with tiller off then attach, Right side turnbuckle wont budge unless weight off
  8. S

    Landpride Tiller Lateral Adjustment

    Trying to do a three point lateral adjustment without removing the implement. Too much tension right adjustment arm will not budge. Had the same tension on the three point blade, had a tip to place 2x4 under blade to remove pressure. Tried that with tiller, no soap. Do I need to disconnect...
  9. S

    G 52l0 Throttle Lever Removal

    Well I have yet to verify if the lift pump is bad, but I had to go to town and drive right past Kubota dealer. SO I dropped in and priced a pump, the counter guy never flinched at 196.00. OUCH!!!!!!! So, i will verify and if needed opt for something like or identical to Bruce solution...
  10. S

    G 52l0 Throttle Lever Removal

    I seen the post on alternative lift pumps, significant costs savings. So tomorrow I will further trouble shoot but my instincts are telling me the pump is faulty, at least intermittently. We shall see. Yes, the cable from the seat to the shut valve operates as advertised, actually cable been...
  11. S

    G 52l0 Throttle Lever Removal

    No fuel being pumped to little filter on block. Tried to bleed, no soap. SO I disconnected inlet, no fuel. I wonder if I disconnected something when probing for the switch bypass wiring. Did not notice any clicking sounds or hear pump running. Dunno what to think, cause it did run for several...
  12. S

    G 52l0 Throttle Lever Removal

    Great Posts: I got it started and it ran for several seconds, then stopped. Not to run again. It does now act like it is starving for fuel. Fuel is below half, but not out. I will see if it is pumping fuel from the small filter. I have had the tractor about 18 months, no fuel filters...
  13. S

    G 52l0 Throttle Lever Removal

    Appreciate the post, good instructions. Maybe I need to review what happened. I took the tractor out and as I approached the grass, it shut flat down, I mean right now. So, I tried to crank it and no soap, starter not engaging. Pushed into garage and checked for battery at the starter...
  14. S

    G 52l0 Throttle Lever Removal

    Yes Sir, I should have been more clear in my post. I understand the safety switches provide power to the solenoid for starting. And not too long ago we replaced the cable from fuel shut off to seat, all working fine. Well all working except once it starts it shuts down immediately, just like we...
  15. S

    G 52l0 Throttle Lever Removal

    Well Eureka!!!! Kinda. I have verified safety switch under HST pedal faulty, or the wiring underneath. Accessed BW wiring from below inst panel and disconnected BW going to HST switch. Connected BW together going to engine, and started, but engine shut off immediately. Done it again, same...
  16. S

    G 52l0 Throttle Lever Removal

    Well, process is slow but moving ahead. I was able to identify the blue with white tracer that (I think) links the two safety switches in series with the hot lead feeding the solenoid. I did verify via ohm meter the continuity on the pto lever switch (left side of tractor) was good. Easy to...
  17. S

    G 52l0 Throttle Lever Removal

    BINGO!!!! Much obliged. Dunno bout removing deck to access the switch, getting a little long in the tooth. My Dad purchased this mower new around 1986, HST model. He has since passed and I just hated to see the mower go for scrap. A whopping 3600 hours and the motor is still strong. My...
  18. S

    G 52l0 Throttle Lever Removal

    Thanks for posting, I see the two safety switches, just trying to identify where they are physically located. Believe the next post satisfies that, but appreciate the post
  19. S

    G 52l0 Throttle Lever Removal

    Ok, no power at the selenoid when the key is turned to start. Still could not identify where the supposedly two safety switches located and I need to confirm the switch is not faulty. Guess I will work on that tomorrow.
  20. S

    G 52l0 Throttle Lever Removal

    I guess i am going to have to get underneath this beast. 1. I see NO switch near the seat, just a cable that connects to the fuel shut off valve. Once off the seat, it closes the valve. 2. No apparent switch on the foot pedal, so it must be underneath the metal more later