B7300 axle cener pivot

[Muggman]

How do you set the lash on the 4wd center axle pivot. I realize you set it with the bolt and jam nut on the front. What is the proceedure.

 

[woodman55]

The kubota work shop service manual will tell you every thing you want to know. They are well worth the money.

 

[Muggman]

The kubota work shop service manual will tell you every thing you want to know. They are well worth the money.

I'm trying to dodge that expense and i don't want something else to keep up with. Just wondering if you tighten it up so much with a torque wrench or tighten it up an back off some amount, then lock the jam nut down. I'm already to that stage.

 

[TheOldHokie]

I'm trying to dodge that expense and i don't want something else to keep up with. Just wondering if you tighten it up so much with a torque wrench or tighten it up an back off some amount, then lock the jam nut down. I'm already to that stage.

Download for free.

Dan

 

[Muggman]

Download for free.

Dan

The closest I could come up with is 11.2-22.5ft/lb for a b2350. I'm gonna jack it up and let the axle swing and put about 15 or 16 ft/lbs on it and let it ride. Thanks

 

[KGBentz]

Download for free.

Dan

Download the service manual for free?

 

[Russell King]

Download the service manual for free?

Try Kubota books dot com. They are usually under the tractor operator‘s manual section.

If yours is not there perhaps look at something similar and see how they do it

 

[North Idaho Wolfman]

I've never found a cheap or free WSM for the B7300.
You can get one from a dealer, or here.

Kubota #97897-12031 B7300 Shop Manual

Kubota #97897-12031 B7300 Shop Manual

www.messicks.com