Recent content by winesalot

So if I found a low hour used engine I would need to make sure it was a V2203-M and I would be good?

My excavator is a Kubota 121-3ss and the engine tag says V2203-m-es. I am interested in more information on what this engine is, what other applications use the same engine? What does the M signify? What does the ES signify? The reason I am asking is I am looking at my options for replacing...

No, still in the machine. I have family in sandpoint and I have a pesky day job trip over there to Albani Falls Dam in a month.

So...If I pulled the engine and delivered it to you my cost would be $5k?

Our quotes came in closer to $10k

I have a Kubota 121-3ss (serial number xxx) that appears to need a new engine. We had smoke and high engine oil use as the main symptoms. A mechanic came out and found the air intake line between the air filter and the intake had broken, and we have been sucking raw dusty air into the engine...

Some unsolicited advice....lol When I am first getting after a driveway I drop the rippers and tip the land plane forward a bit so the rear blade is out of play. After a few passes you have broken up the compact gravel a few inches deep. Then raise the rippers and adjust the land plane so it...

A couple years ago I bought a Rears flail mower. It was a mistake. Most of my mowing is on a steep hill that has fairly sandy soil. The flail is simply too heavy to mow while climbing without spinning tires. I have the flail listed for sale (check the Buy Sell Trade if you're interested). I...

Rears SPF-72 offset y-blade flail mower. Mower was in rough shape when I bought it 4 years ago. I have replaced all bearings, put on a new drive shaft, and changed the oil in the gearbox. Also have a bucket of cutting blades. Mower works perfectly but I ended up need different equipment for my...

Rears SPF-72 offset y-blade flail mower. Mower was in rough shape when I bought it 4 years ago. I have replaced all bearings, put on a new drive shaft, and changed the oil in the gearbox. Also have a bucket of cutting blades. Mower works perfectly but I ended up need different equipment for my...

Any idea where I can download a service manual for my KX121-3SS Excavator? My swing/swivel motor appears to have failed and it's time for a major repair.

I won't be home in the daylight until tomorrow. I'll get a picture and post it then. Thanks for the help.

Thanks for the reply. So you have a curved cutting edge? Can you post a picture? Does this do a good job on concrete/asphalt?

Thanks for the reply. It is old and rusted. No clue as to the manufacturer. Could be homemade even. Turning it over is a good idea. Maybe I will have to make my own.

I purchased a 7' wide snow plow for super cheap. I have welded it to a Mount Plate I purchased from Titan and am working on mounting a couple of hydraulic cylinders for left/right rotation. What I am looking for is a source for a new cutting edge. It is 84" long with bolt holes at 3, 16, 29...