Recent content by tom121212

Thanks for the advise. Although I had to pull the entire seat area out to get at it I was able to free up the valve and everything works properly now. I would have never figured that out on my own. Thanks again!!!!!

Thank you. That seems to be the case. The roll pin/ indicator is all the way to the right at 1oclock but mine is frozen and won’t turn. Is that part 090 a snap ring on the back? I may need to punch it out from the back to get it to turn. It won’t budge and I don’t want to screw up the slot...

It is hard to tell for sure but it looks like the “130” part numbers are the plugs I removed. The top port got the pump line hose and the bottom port got the power beyond hose. When you say the wrong position is it a matter of in and out position or turning it? I see what looks like a hole in...

There are 4 quick connect and 3 lines coming from the tractors hydraulic system. I followed the line configuration circled in red here. The lines were already connected on the loader valve side since it was a takeoff another machine and based on the length and angle of the fittings I’m pretty...

I purchased a 2005 M6800S and sourced a LA1002 loader off of a salvage M6800. After messaging Kubota directly they informed me that that is indeed the correct loader model for this unit based off of the serial#. I was able to figure out through downloading the LA1002 manual how to hook up the...

Thank you. It turns out it is a manual shift unit. Luckily I only did this two or three times for a few seconds and everything seems to be operating properly.

Just purchased a used M6800 4wd and am using it for the first time. To the left of the seat on the floor there is an H pattern shifter allowing you to select reverse ,neutral and low and or high if moved to the right side of the shift pattern. The info I can find says this model has either a...