Recent content by Spam Bot

When you get the cash, I have a bridge in Brooklyn that I need to sell. I will give you a hell of a deal on it, and you can set up a toll booth and charge to cross it and make your money back.

Don't forget to add something for cleaning the tractor after the job.

I needed one part for my Snap-On Puller set, and Snap-On didn't service that one little part. They sent me a return label to send the entire tool back to them, and they sent me a complete new tool set. They charge a lot for their tools, but they stand behind them no matter how old they are. I...

Get a proper main breaker lockout for your electrical panel, and wire the generator to your main panel correctly. No excuse for not doing it properly, and you may save someone's life if you forget to shut off the main breaker. Generator Interlock Kit Compatible, Homeline 150 or 200 Amp...

Many times, a manufacturer calls an item "out of stock", but the truth is that it is no longer carried in inventory because, for the most part, it is obsolete. Some savvy reseller will purchase all the remaining stock from the manufacturer for pennies on the dollar, and will list it on Amazon...

What difference does it make if he were a Mexican, or, for that matter, any other nationality? For a website that says "no politics," many posts in this thread seem to be skirting that "no politics" policy.

Sometimes it is faster and easier to cut the hose in the middle: use a sharp razor to cut the end lengthwise, then carefully roll the rubber hose off with a pick. Do the same on the radiator side and replace it with a new rubber hose from the auto parts store. Doing it this way will allow you...

Try jumping the tractor off of your car or truck. Many times the battery will have enough energy left in it to cause the solenoid to click, but not enough to turn over the engine. Use a good pair of jumper cables, not some wimpy, cheap, thin copper wire, for best results. If you don't have a...

Looking at the parts breakdown of the BX2822, it appears to be quite complex. If Kubota doesn't offer a WSM, do you know if RAD offers one to the dealerships? thanks

Thanks for that information. Does Kubota ever issue workshop manuals for accessories it sells, like a snowblower or a rear tiller?

I found the problem. On the left side of the rear of the blower, a small piece of steel had either cracked or torn away and was sticking out just enough to catch on the edge of the fan. Using a large pair of pliers, I was able to bend it away enough for the fan to clear it. I also realize...

Only if it is properly pounded in place after pouring.

Before Teflon tape, we used pipe dope and cotton thread to take up the gaps.

The OEM turf tires that came with my 2019 BX23S are showing signs of sidewall cracking, whereas the BX22 (2003) that came with turf tires was still crack-free in 2019 when I sold the tractor. I did have to replace the rubber valve stems after about 5 years, but that was a simple task using a...

Use Locktite 640 or 660 on it, and make sure that the tractor is in a warm garage when you do the repair. Allow 24 hours for the Locktite to set up. Next time it needs to be replaced, you will need to use heat to break the Locktite bond.