Recent content by sgec

Thank you so much! I'm assuming with the slight bend I should still be able to align it.

Translated from Japanese: 17 38440-4487-0 Tie Rod End Right Comp 21 38440-4488-0 Tie Rod End Left Comp 24 02174-50160 Nut 25 32240-1228-0 Nut 26 38380-4404-1 Tie Rod

It goes from wheel to wheel.

Thanks. I will do that. But first I wanted to be certain that it should be straight. Its difficult to find info on the original part number 38380-4404-1.

Did the L275 35290-43960 tie rod work as a replacement for the 38380-4404-1? Is it straight?

Is the tie rod for an L1802DT supposed to have a bend in it? I'm guessing it should be straight. Any harm in continuing to use this one (assuming I can get the alignment right)?

Did you ever find a a tie rod for an L1802? The 35220-43960 looks similar.

I'm attempting to install #70000-00297 Block Heater Kit on a L1802DT. The left middle freeze plug seemed like it was a possible location but after removing the starter and installing the collar it looks like there is no clearance to put the starter back on :( So I would like to remove the collar...

Thank you! The pin (9) going through the hole (5) explains a lot. That puts the key (2) by the lever. I noticed there is a notch in the lever where it attaches to the spindle. Does that have anything to do with the key?

Thanks. I've been dousing it with penetrating oil just today. I like the idea of a puller. I'm wondering if something like this would be strong enough.

Thanks. How does the key(2) work? Like can I manipulate it somehow to remove the spindle? It's a little hard to get at. I can see (9) but not (2).

So here's a photo of the parts in the box on the diagram (1)(3)(4)(6). It seems to me that once the bolt is removed the lever should come off. It's probably never been off for like 40 years so it's likely rusted on there. I've tried penetrating oil, heat, tapping with a hammer to no avail. I...

I'm trying to remove the throttle lever (1) on an L1802DT. Looking at the parts diagram it seems I should just be able to undo the bolt (4) at the end of the spindle but after removing the bolt (4) the lever (1) won't budge or come off the spindle. Any suggestions?