Recent content by Rxreminder

  1. R

    BX2670 FEL drifts down, main control valve?

    Took it to a local guy & he heard from another shop it’s the pressure relief valve in the back of the tractor. He checked from valves & spindles & all good. Waiting for a quote from the dealer of the PRV to replace. Hopefully that’s it. Saw other posts saying some factory settings on the PRV are...
  2. R

    BX2670 FEL drifts down, main control valve?

    Since there is no external leak & this tractor has <200 hrs on it, I’m going to call back & ask those details....at $2200, worth a second guess. Thanks!
  3. R

    BX2670 FEL drifts down, main control valve?

    Yes, mostly the bucket drifts down, but the arms of the FEL do also. I run the tractor at higher speeds so the drift isn’t as bad, but still have to keep lifting the FEL
  4. R

    BX2670 FEL drifts down, main control valve?

    BX2670 FEL drifts down, hydraulics do not hold. Dealer diagnosed as the main control valve controlling tractor & FEL. $2200 to repair.($1000 for part YW-547-001-02 & rest labor). I can not locate that part online so a local shop (not $85/hr) can do the repair. Any suggestions of an alternate...
  5. R

    BX shuts down trying to engage mid PTO

    Looked under seat for safety seat switch, couldn't find anything in the manual. Where is it or what does it look like?
  6. R

    BX shuts down trying to engage mid PTO

    Thanks to all for the input & lightning fast responses! Per bxray I tried the rear pto & it still worked. Looked under deck again & found the blade stuck against bent housing, keeping mid pto from engaging. Knocked blade back w/hammer & pulled housing bend out with crow bar. All back working...
  7. R

    BX shuts down trying to engage mid PTO

    Recently bought bx2670 w/50hrs, new mower. Hit a hidden tree limb w/mower & tractor shutdown. Tractor starts but shutdown when engaging mower/midPTO. Hoping it's just a safety switch reset somewhere? Any suggestions? Tried turning off tractor, switching to rear PTO, & turning mid shaft manually...