Recent content by plumber mechanic

  1. P

    MX4800 HST oil change…go synthetic or stay with Kubota brand?

    I've been considering switching from conventional oil to synthetic in my Kubota L2550 (758 hours). After looking at the lab video posted in this thread, it sounds like synthetic is the best way to go. Can you get a good synthetic oil in 10w 30w as recommended in the owners manual (I'm located...
  2. P

    L2550D Power Steering Sometimes Momentarily Is Hard To Turn

    Got it Wolfman. I'll check out the power steering section and see if that helps. Thanks for your excellent help.
  3. P

    L2550D Power Steering Sometimes Momentarily Is Hard To Turn

    Thanks for responding. No I do not have a service manual.
  4. P

    L2550D Power Steering Sometimes Momentarily Is Hard To Turn

    The power steering on my L2550D works for the most part but every once in a while when I'm stopped and turn the steering wheel for a moment it doesn't react and then about a second or two later it's fine. Is this something to worry about or just a common situation for this tractor? Thanks for...
  5. P

    Need to find out how to dismantle scraper blade pivot from hitch unit

    Hey thanks for the reply. I far as I can tell I have the same unit (Leinbach) as you. And yes if I adjust the 3 pt lift arm I can get it to be level (and it does swivel). As a matter of fact it tilts to the right and about the same angle as yours in the photo. pretty coincidental it makes a...
  6. P

    Need to find out how to dismantle scraper blade pivot from hitch unit

    Got it...it all makes sense now. Thanks so much for your help.
  7. P

    Need to find out how to dismantle scraper blade pivot from hitch unit

    Thanks for responding....just to make sure we are on the same page. My photo may not be the best as it looks like the vertical tube going up to the top flat plate is welded to the bottom triangle plate . However, that tube fits out over and swivels over the tube that is welded. I've been...
  8. P

    Need to find out how to dismantle scraper blade pivot from hitch unit

    I have a used scraper blade that I got for my Kubota some time ago. I currently have the blade disassembled from the 3 point hitch portion of the scraper for re-painting. I noticed shortly after I bought it that the blade was uneven and it appears that the pivot shaft must be bent. There...
  9. P

    Bolting a L2550DT front axle assembly back to front wheel assembly case

    Yes you are correct....Since my earlier posts and finally getting a chance to crawl under the tractor, I have found the bolt heads do have a "9" on them and that's the torque the WSM lists for a M14 bolt. I am leaning towards the big "O" ring must be leaking (inside the axle case where it...
  10. P

    Bolting a L2550DT front axle assembly back to front wheel assembly case

    Thanks Wolfman for the follow up. I got the bolt size by getting the Kubota part number then doing a search of the part number and two different sources verified that it is size 14 mm. The bolt head takes a 19mm socket. But again thanks for the caution. I like how you cover all the bases...
  11. P

    Bolting a L2550DT front axle assembly back to front wheel assembly case

    Yes...I dealt with "O" rings before but I am always open to good advice....Thanks
  12. P

    Bolting a L2550DT front axle assembly back to front wheel assembly case

    Thanks Wolfman. I found the bolt size is M14 and according to the manual the torque should be 91.2 to 108 ft lbs for grade 7 or 123 to 144 ft lbs if grade 9. At this point I'm not sure what grade the bolts are until I turn them out.