Recent content by Pcekpr

  1. P

    Third function valve wires

    Problem solved. I found the system was made by rw long. I called the company and left a message. My call was returned and the gentleman provided a part number for the upgraded part that was hard wired and no phone jack looking plug to be pulled out by brush! The part number was VALCMWW and...
  2. P

    Third function valve wires

    Thank you for the reply. I'll try them tomorrow and hopefully they will have the part. I will add to the post when I find the solution!
  3. P

    Third function valve wires

    That sounds great! I need to figure out how to get the guts out of it without breaking something else! I'll try it tomorrow, weather permitting. I called the dealer and learned the type of valve I have has been discontinued! If worse comes to worse, I may have to see about hardwiring it to...
  4. P

    Third function valve wires

    Thanks for the reply. The first wire of three broke even with the plug. I broke the second wire while seeing if I could take it apart. Too short to solder so plan B will be to try removing the insides and reconnecting them to the wires.
  5. P

    Third function valve wires

    The wires for the valve broke at the plug where they plug into the module. Can the end of the plug that looks like a phone jack be replaced or do I need to buy the wire harness itself? Any assistance is appreciated. Thanks, Donnie
  6. P

    FEL loss of power

    Thanks again!
  7. P

    FEL loss of power

    Thank you for the information. Hopefully I will be able to check that by the weekend. Could very well be the problem. When I got stuck, I had the disc on the 3 point and old have put too much pressure on the wrong parts. I just want to fix it so it operates correctly. Some things can be...
  8. P

    FEL loss of power

    I have an L3901 HST. It has developed a problem. If the three point lift is is fully lifted, there is very little power to the FEL. I can move the implement lever forward to the middle of its range and the FEL functions fine. Fluid level is full. I change the engin oil and filter and both...
  9. P

    New BX2380 bucket meets ground unevenly....

    I had a problem like that and worked on the quick release with good results. I took off the bucked and tilted the arms all the way forward and lowered to a level concrete pad. I put a 2x4 under the lowest arm and raised the front of the tractor with the FEL and repeated until it was level. I...