Recent content by OldB7500

Jim, you have shared some great help. Wiring diagram show's dash wires as 0.5 win =20 gauage AWG. So far I have not cut or botched anything keeping tractor all original.

Just wanted to ad that to better fight or prevent the blue oxidation/corrosion to my dash traces I am going to use a product called Ford Motorcraft XG12 . It is an electric grease . Dialectic grease is not the best in this application..

Also what size guage wire to look for.

OK an update to all the tech help you shared. 1) Used Detoxit 5 $20 / can 2) Placed copper adhesive conductive tape on RH turn indicator where pins touch when terminal block plugged in. 3) Used one strand of old 4 wire phone cable to connect backside of terminal block to dash bulb socket contact...

OK Kubota wirING help. Update. I used some adhesive backed copper tape to help test. As of today all circuits except one have power to the terminal block pins. I amp going to use a piece of yellow copper phone line as a jumper to glow light indicator hot circuit. All other dash lights,are...

In OK all good tech useful to my problem Will post any progress.

OK great help on what to purchase also to build up the contacts. I am leaning towards corrosion in the pins since most of the board looks great.

Jim L: Thank u for your quick and helpful reply. I just c went back out. I have one very solid bright left turn. Through only bare trace is circuit down 3 from the top on the bottom set of circuits looking from the back of the board. I can see I rubbed 2 hard and whie shows no copper in 3 spots...

Hey electrical service helpers, I am trying to find out if there is a way to repair these so my dash lights function again. I tried cleaning with DeOxit5 and now have a faint left turn indicator. Nothing else. Is there a way to bridge broken copper pcb traces? Could key switch be problem, note...