Recent content by Nickk

Thanks Wolfman!

My tractor has about 1500 hours but the first owner was not kind. I believe I need to replace the front right seal that is closest to the hub. Any guidance would be appreciated. I have broken too many things when there was a hidden snap ring or a special way to rotate something for...

I have the glow plug issue. where did you wire the switch in? Wire colors? thanks

My current set up is not factory the 27-8.50 with the 355-80. These give me a ratio of 1.56. I did see slippage at times with only the front which seemed odd to me. Being direct drive both wheels should be wanting to move the same distance.

https://www.tacomaworld.com/tirecalc?tires=27-8.5r15-29-12.5r15 This site (even though it is for autos) helped me understand the proportional size of front to rear wheels. North Idaho Wolfman's great help it looks like a ratio of 1.5 to 1.45 would be good.

I would like to run R4 tread and a 16" rim. I am having a little tougher time finding a 15" tractor rim with the an offset of 3.5". 3.5" is what the rim currently on the tractor measures.

When I look on Tractor data (usually a pretty reliable site) I see my rim size to be 16" front and 24 inch rears. The tractor has 15" front and 20" rears on it. I know older tractors can some times have the wrong rims on them. Messick has options of 16" and 15". Questions: -Being 4 wheel...

I thought I would post what I decided to do for a grill on my 3600. It is all steel does everything a grill should do. Locks in place with hood lock. Hope this inspires others that want a grill.

Thanks for the suggestion. I have tried a general search and then went to sites mentioned on here. I have not been able to find this cylinder; I have contacted each of the potential suppliers and they have responded with no replacement; accept Kubota, they have one that must be made of gold :).

Hey Michael, I am in need of the same cylinder. Just wondering what you ended up doing?

Thanks everyone!

Sorry for being a little dense. It looks like poppits are under the connector for hoses.

Nice great advice. The poppit is under the circular cover on the left?

Sorry for not listing it. LA680 - the L3600 is with ROPS. The valve has the

I think it is how I am using it but I think it is allowing to do this because of an issue. 75% the loader controls work exactly as they should; but every now and then I am surprised. 1. Occasionally pulling back gently and slowly on the lever will cause the loader to drop and then it goes up...