Recent content by Ngiovan

Made some progress. Another rainy week here in PA, so at least I’m not missing time on the tractor. When removing the hard lines to the loader, one of them twisted while i was wrenching on it (pictured below). Thought I’d do the right thing and get a genuine replacement from Kubota but the...

Picked up the o rings this week, and finally getting into the tear down. Man, they really make you take a lot of stuff out just to get to these… i have half a mind to just cut out enough of the battery holder to access the fittings below.

Would love to see an update on this. Im going through the same issue on my BX24 right now.

Found the leaky fitting. After cleaning it up there was some o ring visibly blown out. I did snug the fitting up a touch which slowed the leak. Looks to be the line that articulates the bucket. I’ll order up replacements tomorrow. Since I’m this far in, should I just replace all of the o...

Jinxed it, rained all day today. I was able to dig into the leak a bit more and looks like it’s coming from the manifold. Read some posts from guys that just had to tighten things up, others had to replace the lines. Here’s a quick Video of me poking around.

Finally got around to getting it back to level. Still has a leak, but has noticeably slowed. Mentioned it to my local dealer when I stopped in for some mower parts and they printed the same picture that @North Idaho Wolfman posted and said it was likely the culprit. I’ll look to address it...

Thanks for the feedback! I’ll get it back to level tomorrow and report back.

Hey guys, Did a HST Service last week, and I’ve noticed a Leak since. Maybe an overfill? Seems odd that it just started

All set! Thanks again for the help.

Ground on the back of the wiring harness was out. Popped it back in and everything is working as it should. now lets just hope I can button it back up without tugging it out. thanks for the help!

Tried the old panel again and it lights up just fine and the gauges that worked before still work. Went back to the new panel and same issue, only dim turn indicators. The only difference is that the replacement kit has a line that runs to the positive terminal of the battery. No dedicated...

Im gonna pull it back out this afternoon and see. It is the full kit with the panel and wiring harness/adapter. Old panel worked when I removed it (other than hours meter) so i’ll pop that back on and see if that works too.

Got my new (to me) bx running a few weeks ago and noticed the LCD hours meter was dead. Seemed to be a common issue with these, so I went ahead and got a new panel kit from Kubota. Install went fine, tested the panel before snapping it into place and everything looked good. Snapped it in and...

Got it running today! A little smokey for the first few minutes and then it cleared up. I was told to go easy on it for about 10 hours and then change oil and filters. Only issue is my hours lcd is blacked out. From a bit of googling it seems to be common on these and I’m probably looking...

Spot on, as always Wolfman. Once I got it routed correctly I found rather significant wear on the hose. I’ll grab a new one, but want to make sure that doesnt wear the same way as the old one. Not sure if the issue was belt tension, hose routing, or a combination of both