Mountainman's latest activity

  • Mountainman
    Where did you get the new lift pump? If its a china special off amazon they are hit and miss and may very likely got a bad one.
  • Mountainman
    Mountainman replied to the thread B 7100 Fuel Tank.
    I have a few of them in northeast Alabama.
  • Mountainman
    Mountainman replied to the thread B 7100 Fuel Tank.
    Thank you sir
  • Mountainman
    Mountainman reacted to North Idaho Wolfman's post in the thread B 7100 Fuel Tank with Like Like.
    Send @Mountainman a PM he might be able to help.
  • Mountainman
    Mountainman replied to the thread B2150 wheels and tires swap.
    Rear would be fine. Fronts however on the b2150 use the old style 6 bolt rim and 3300 uses new style 6 bolt rim. Bolt pattern is...
  • Mountainman
    Most likely a safety switch. Seat is common. But also make sure pto is disengaged. While holding key in start position wiggle pto lever...
  • Mountainman
    Mountainman reacted to Mr. K's post in the thread Ads + Paid Membership Benefit Update with Like Like.
    Hey everyone, Mr. K here - For approximately the last month OTT has been operating without any ads at all as we migrate to a new ad...
  • Mountainman
    Mountainman replied to the thread Kubota B7200 4wd not working.
    That's no good. I have parts here when yoi figure out what you need. Your also welcome to send me a message with your phone number...
  • Mountainman
    Mountainman replied to the thread New guy with a B7200HSTD.
    B7200 was made from 83-90. Tractor years are based on when they were sold not when they were made. So one made in 1990 but sold in 1992...
  • Mountainman
    Mountainman replied to the thread FAST B7100.
    I appreciate that. Its always my goal to help people fix their tractors primarily and sell parts secondary. What people do with my...
  • Mountainman
    Mountainman reacted to JRHill's post in the thread FAST B7100 with Like Like.
    The problem is the backlash on the steering shaft, ball nut and bearings. Many thanks to @Mountainman for hinting, ever so graciously...
  • Mountainman
    Mountainman reacted to Russell King's post in the thread Kabota B8200d with Like Like.
    Then you should verify that the stem is actually rotating when you rotate the hex. After that clean or replace the filter or screen. I...
  • Mountainman
    Mountainman replied to the thread HST For Dummies.
    Watch the youtube videos then ill add this. 2 cylinders with pistons in them. The pump cylinder does nothing while in neutral. When you...
  • Mountainman
    Mountainman replied to the thread Kabota B8200d.
    Like @D2Cat said check the valve on the hydraulic block down by your foot. Closed the 3 point should work but not loader. Open they...
    • 1000015178.jpg
  • Mountainman
    Mountainman reacted to JRHill's post in the thread FAST B7100 with Like Like.
    Each time I tried to write a negative review the Amazon website malfunctioned and deleted everything I tr Yes, @Mountainman , I will...