Recent content by jim.grove1

Showing my ignorance. What equipment do I need to resolder the pins? Do I add solder or just reheat? If adding solder what should I use. I am willing to try but need some instruction. I have soldered copper pipes and large wires, but never connections on a circuit board.

Another question. Is there a way to repair the connector on the wire bundle if I find that a loose wire is the problem?

Took me a while to get to testing. White wire with sensor disconnected = infinity White wire with sensor connected = 9.90 k ohms - in garage at room temperature Ground wire with sensor connected = 7.85 k ohms Other information: got same readings by testing pins on back of panel Back of panel...

Yes that is the sensor I changed. Any advice on how to pull the instrument cluster? What should the white wire ohms be? Also when I had the sensor disconnected the temperature gauge still read 5 bars.

I have a Kubota 3240D that the temperature gauge is not working properly. It shows 5 bars when cold as soon as the key is turned on. I have replaced the temperature sensor just below the thermostat and it did not change. As soon as the tractor starts to warm up I get a message that it is...