JasonW's latest activity
-
JJasonW replied to the thread L2501 Overheats under load.I would say it’s probably fine. But it’s almost ten years old and the manual states to change coolant every two years. So couldn’t hurt...
-
JJasonW replied to the thread L2501 Overheats under load.As said above make sure there isn’t debris in the radiator fins. Also check the fan belt tension, it can’t cool off if it can’t move air...
-
JJasonW replied to the thread Low RPM on PTO.Every time I’ve ran a PTO spreader I’ve ran it lower than 540. You didn’t mention if your tractor is a gear drive or HST. Gear drive...
-
JJasonW replied to the thread LP RCR1860 cutter lost Power.Thanks for the follow up. Always keep a few spares with you.
-
JJasonW replied to the thread M5400 won't start, have changed most everything.Yes
-
JJasonW replied to the thread M5400 won't start, have changed most everything.Not 100 percent sure but on that model the neutral safety switch should be in the F-N-R lever. Not internal to the transmission. I’d...
-
JJasonW replied to the thread Dealer runaround?.Didn’t that model have a bulletin about fuel pump issues? Sounds like they are correcting it before you pick it up. One week delay? Are...
-
JJasonW replied to the thread Radiator Recovery Tank leaks.I repaired a small hole in a plastic gas tank on a ZG127 with two part epoxy made for plastic. Not sure which brand it was though. The...
-
JJasonW replied to the thread BX1500 Diesel running cold..Sounds like two separate issues. Stalling more than likely is a fuel issue. Does the temperature gauge move at all when you turn the...
-
JJasonW replied to the thread P0101 (Intake Air Volume: Low) Warning after replacing dirty air filters.True I completely missed that part.
-
JJasonW replied to the thread P0101 (Intake Air Volume: Low) Warning after replacing dirty air filters.If it happened right after you installed new filters what are the chances you damaged a sensor or wiring?
-
JJasonW replied to the thread LP RCR1860 cutter lost Power.Either broken shear pin or very loose slip clutch.
-
JJasonW replied to the thread MX 5400 Canopy mounted fan.That’s why I added wired and fused correctly. All of mine have been added with auxiliary fuse blocks with proper wiring, relays, and...
-
JJasonW replied to the thread MX 5400 Canopy mounted fan.I’ve ran one on all three tractors that I’ve had. As long as it’s wired and fused correctly. Just give enough room between the fan and...
-
JJasonW replied to the thread M7040 shuttle problem.Maybe you missed it. You do not need to remove the tire to drop the fuel tank.