Recent content by Jarhead2147

My repair manual is missing Fig 156. Does any one have that picture they could send me?

Thanks for the advice. Don't know what I did but it has worked for quite a while now. That is until I rebuilt the engine. Now it is doing it again and worse. The only filter is a screen, it is clean. It has new oil and filled to correct level. You don't know what size adapter is need for the...

No lift pump on it. Update, somehow the fuel was going through the injection pump. Replace the injection pump and no more fuel in the crankcase. Expensive way to fix it I am sure but I don't have the know how to rebuild the pump. Even Kubota tells you to leave it to trained specialists.

No lift pump on it. Update, somehow the fuel was going through the injection pump. Replace the injection pump and no more fuel in the crankcase. Expensive way to fix it I am sure but I don't have the know how to rebuild the pump. Even Kubota tells you to leave it to trained specialists.

L245H - There was a fuel leak coming out from under the tractor. I couldn't see where it was coming from but just out of curiosity I pulled the engine oil drain plug and there was approximately a gallon to two gallons of diesel in the crankcase. The only thing I can think of is it is coming from...

Just purchased a G4200. Previous Owner couldn't get it to start. Put in a new 10amp fuse and it now starts and runs great. Has less than 1000 hours on it. Now I need to replace the cracked seat. Any suggestions for a replacement? A new one costs more than I paid for the entire mower.

Just purchased a G4200. Previous Owner couldn't get it to start. Put in a new 10amp fuse and it now starts and runs great. Has less than 1000 hours on it. Now I need to replace the cracked seat. Any suggestions for a replacement? A new one costs more than I paid for the entire mower.

So, after all of the effort put in, the 3 point hitch stopped working again. Now the pump sounds strange and there is a weird vibration. I am tired of all the problems and know that I probably shouldn't, but I am buying a new hydraulic pump as that is the only component other than the relief...

Update: Took the rock arm assembly back off. removed the shaft that raises the lift arms. Rotated it two spline positions. Disassembled, cleaned and reassembled the control valve, reinstalled everything and it now works.

I have checked the linkage but, as stated previously, I don't have a very detailed procedure for the adjustment. Would you happen to know where I could get a more comprehensive description of how to properly adjust the linkage?

Looking for a control valve and a relief valve

The hose is new, I replaced it when the lines were removed. Sweep valve? Pardon my ignorance as I am not familiar with what that is? I double checked the parts diagram and could not locate it via the diagrams. The only valves I am familiar with are, relief and control. Both of which have been...

Update: I tested the pressure coming out of the pump by removing the flange (red arrow) and bolting a plate with a 3000 psi gauge attached to it. I got a reading of approximately 2100 psi. I shut it down quickly so the pump wouldn't be deadheaded too long. I think this eliminates the pump being...

If you have a L245 and parting it out, please let me know

In the photo below, I removed the plug and installed a 3000 psi gauge. I did not get any reading. I removed the gauge and with the tractor running at an idle, then at a higher rpm, oil flowed out but it did not have any pressure.