Recent content by ionstegarus

  1. I

    Shuttle lever doesn't stay in forward or reverse position

    Thank you for your response. I think the GST system is similar in more models of tractors. Do you have a WSM for a tractor similar with GL35 with GST?
  2. I

    Shuttle lever doesn't stay in forward or reverse position

    I have a Kubota GL35, with GST transmission. The clutch case was broken and I changed it (marked with blue). Also the shaft was chipped (the shaft is marked with red) The shaft was chipped at the end where the circlip 190 is mounted. I made a new channel (a smallest channel) for a smallest...
  3. I

    My Kubota don't want to move (up or down) the 3Point hitch

    The command of the 3pt is electrical
  4. I

    My Kubota don't want to move (up or down) the 3Point hitch

    I t I tried to do this, but it not working
  5. I

    My Kubota don't want to move (up or down) the 3Point hitch

    Hello, The 3HP is up now. The knob is open, it is positioned on the middle (half) between close and open.
  6. I

    My Kubota don't want to move (up or down) the 3Point hitch

    Hello, I have a Kubota GL35 and it don't want to move (up or down) the 3Point hitch. The 3 point hitch remain up. Can you tell me what should I test? and how can I test? What can be wrong? Also, the command of the hydraulic cylinder (which is located on the right side of the tractor)...
  7. I

    Kubota break light switch

    Thank you Dave, It's correct, I am from Romania. My Kubota Grand L 35 don't have brake light and now it is mandatory to put brake light. I saw the WSM for Kubota L3130/L3430 and they have the switch. Can you recommend other brake light switches which are suitable for my Kubota? Thanks
  8. I

    Kubota break light switch

    I need a part # for brake light switch wich is used in Kubota L3130 or L3430 Thanks
  9. I

    Kubota break light switch

    Hello, I need the p/n for Kubota L3130/L3430 break light switch. Please see the attached picture
  10. I

    Kubota L35 changing gears issues

    Any idea? Thank you
  11. I

    Kubota L35 changing gears issues

    Opinions? How can I decontaminate high low valve? How can i verify if it is damaged? How can i repair the high-low valve? Where is located the high low valve? Thank you
  12. I

    Kubota L35 changing gears issues

    Thank you for your response, I don't have the WSM my Kubota, but I found the WSM for other models. It was correct, the rotary valve was put wrong. I rotated the rotary valve and now it's ok. but now, i have other problems: - for Hi speed when I change the gears (from 1 to 8) it have a delay...