gssixgun's latest activity
-
Looks like might be inlet line..?? Here is a link to Messicks I believe it is part # 70 in the parts diagram. Hope this helps... -
If the line is not kinked, bring it over and I'll put a new tab on it and you should be good to go.
-
gssixgun replied to the thread Hydraulic Pipe Pulled out.That might work,,, but I have a set of Easy-Outs just in case
-
And you have a bolt broken off near the filter I think! I believe both ends of the tube are held in place by a tab with a bolt through...
-
gssixgun replied to the thread Hydraulic Pipe Pulled out.I get out there and pull it off and get the numbers this week.. Figures I was just about done when it happened too
-
The good part is that the bolt that is broken off is in the filter housing, so you could pull that and get it on a bench to get the...
-
gssixgun replied to the thread Hydraulic Pipe Pulled out.Non HST Thanks will search it out
-
If the above model is incorrect you will have to put in the right one.. Wasn't sure if it is HST model or not.
-
Doing a little Brush Pile work caught a branch and ripped out my Hydaulics 2000 L3600 The pipe feeds to the Filter housing Here are...
