GreensvilleJay's latest activity
-
GDownload AdBlocker its a free down load and it works
-
GGreensvilleJay replied to the thread Worn out 3-pt lift arm ball & socket - L275DT.FYI.... BEFORE you 'cut and weld'.... measure the 'eye to eye' dimension ! While not 'mission critical', always best to weld new ones on...
-
GGreensvilleJay replied to the thread Thinking about under fence weed control.really 'old school', used in vineyards, is to direct steam to the bottom of the fencing. Guys mount a 'steam genny' onto tractor,point...
-
GGreensvilleJay replied to the thread Grade 5 Shear Bolts.That groove is the 'weak' point of the 'shear bolt' and usually it'll be aligned with where the 'shaft' and 'coulping' meet. Suppose it...
-
GGreensvilleJay replied to the thread Worn out 3-pt lift arm ball & socket - L275DT.simply cut off the old, weld on the new the be sure to grease them OFTEN.
-
GGreensvilleJay replied to the thread Land plane size..possible option... once driveway is 'restored'... .... The late farmer across from me only ever used a steel bar with chains behind it...
-
GGreensvilleJay replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.1st issue the 'battery cables' . Both of those need to be replaced with nice,new molded ended ones. A LOT of 'electrical issues'...
-
GGreensvilleJay replied to the thread Box Trailer BX23S.Odds are good your F-150( > 1996) is already prewired for a brake controller. Look under the dash wher ethe OBD-II connector is, should...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.no Hall sensor, just 1/2wave DC signal from alternator. All the 'signal conditioning' is done in the 'dash computer'. 'They' obviously...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.'close but no cigar' Tach is usually 'RPM' a number of Revolutions per Minute, wheras 'Frequency' is the number of transitions or...
-
GGreensvilleJay replied to the thread Tachometer 'Flutter'.curious so checked, yes cable driven, so odds are cable is 'damaged', maybe from being kinked or bent too sharp. best to remove from...
-
GGreensvilleJay replied to the thread BX2380 Mower Deck Help.don't have one but think mower number -bx23 or similar should be on the tag ? since you're in the USA, try to 'build a BX' and look at...
-
GGreensvilleJay replied to the thread Offsetting rear blade ... should I grease it?.I use red spraybombs of 'Rustcheck' for things that need sliding, like pallet forks and PTO shafts. It's not 'thick' like grrrrease but...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.yes, sure sounds like the alternator is NOT sending the pulses to the cluster. If you have a DMM with 'tach' option, probe the 'tach'...
-
GGreensvilleJay replied to the thread "New" Mower. Tell me How I Got Cheated.re: There is no schematic for the controller. That is annoying. It would be nice to know exactly what's happening in there. It would...
