Fedup's latest activity
-
FFedup replied to the thread L185DT: Wrong bolt in transmission?.Find the diagram that shows the reverse idler and the shaft it rides on. I'll bet that bolt is a retainer for that shaft. When properly...
-
FFedup replied to the thread M7040 - AC works but blows hot after a while.All sorts of "possibles" mentioned, but before changing anything I would pinch off one of the heater hoses and try running like that for...
-
FFedup replied to the thread L3901DT Hydraulics Not Working.I certainly wouldn't pull the pump and start tearing it apart just yet. It's not all that uncommon for a pump to lose prime sitting for...
-
FFedup replied to the thread Hydraulic issues..The ones that matter are those numbered 1,2, and 7. Which one goes to the pump? Where on the tractor do 1 and 2 go?
-
FFedup replied to the thread M4700 hydraulic pump replacement question.Not to worry. It will take care of itself. Just check your engine oil dipstick after you run it a few minutes.
-
FFedup replied to the thread M125x won't shift above 4th gear.I take it you agree that it's still a calibration issue? That's the solution here? Maybe you're right. I'm not saying calibration...
-
FFedup replied to the thread Did I get a bad piston ring from Kubota?.I see this as just another example of why each and every part needs to be individually scrutinized before assembly any more, no matter...
-
FFedup replied to the thread Daily Chuckle.And so was it done!!!
-
FFedup replied to the thread M125x won't shift above 4th gear.So both you guys think this a just a calibration issue? I'm not saying you're wrong, just that I don't see it that way. From what I can...
-
FI have an upcoming project involving bobcat 7753 skidsteer with what I believe is a V2203 engine with water in the oil. Is there an...
