Edke6bnl's latest activity
-
EEdke6bnl replied to the thread Are all pallet forks created equal?.Plus adjustable with forks and your good for any pallet There are different spacing for the vertical mounts, there are different length...
-
EEdke6bnl replied to the thread B7800 will not start.On my b7800 the seat is not jumpered and if you get off the tractor it will stay running if the break was not on and it move a small...
-
EEdke6bnl reacted to Dave_eng's post in the thread B2400 - overheats when mowing after ~20 minutes with
Like.
Make certain air can easily flow thru your radiator. Most models have a screen to catch debris before it clogs rad find. Make certain... -
EEdke6bnl reacted to GreensvilleJay's post in the thread L3901 Tractor runs 5 minutes then stalls with Like.
try removing or unscrewing fuel cap and see if it runs fine ?? 'junk' in tank ??
-
EEdke6bnl replied to the thread B7500 Knocking.Sounds 0k to me, Enjoy it.
-
EEdke6bnl replied to the thread HST pressure tester?.KUBOTA JailBreakYourTractor Pressure Boost kit W/Gauge Hydraulic Shims BX +25%! Flat FACE *2017 & UP...
-
EEdke6bnl replied to the thread B7800 will not start.Turn key to on and move pto back and forth then off same with throttle pedal. Try to push switches under seat, may be sticky. Also press...
-
EEdke6bnl replied to the thread 3point wood chipper.I have always thought along the lines of taking a gas operating chipper and powerong it with the tractor 3 point.
-
EEdke6bnl replied to the thread Tilt control adjustment.I would be curious if it is binding, might disconnect and see if it moves better.
-
EEdke6bnl replied to the thread Oil/fuel leak.Could choose the most likely leak and add a die that can be identified with UV light
-
EEdke6bnl replied to the thread 150 gal 3 Point Sprayer.maybe it needs some priming, I would put some water under pressure into the inlet. I am not familiar with that unit though.