Dustball's latest activity
-
DThe connectors I ordered came in yesterday and they're going to be perfect for my application. I don't need them to be waterproof, but...
-
DDustball replied to the thread Snow plowing using blade with rubber edge.I retrofitted a couple of my wide pusher snow shovels (30 inch and 36 inch) with thin UHMW wear bars 19 years ago- wear bars are still...
-
DDustball replied to the thread Extend kubota snow plow 6 inches on each side.I used 10" baler belting. Stiff enough to collect loose snow but has enough give to deflect around hard objects. Fastened with bolts...
-
-
DDustball replied to the thread B3350 service/repair manual needed in pdf form..For a signal to be sent to the starter, the HST pedal needs to be in the neutral position and the PTO lever needs to be disengaged. If...
-
-
DDustball replied to the thread Step up my fueling game.My bad. I read this and assumed you were swapping batteries/chargers/pumps in and out frequently and there was no mention of using a...
-
DDustball replied to the thread Step up my fueling game.I don't know if I would have chosen that style for frequent connnections and connections made under load- they weren't designed for...
-
DDustball replied to the thread Does tire grooving really work?.Buy another one. After you use it, you'll find the first one you already had.
-
DDustball replied to the thread Inverted Snowblower Good, Bad, Ugly.This guy owns a snow removal company in Sault St Marie and they run nothing but inverted blowers on a fleet of mostly Kubotas. Watch...
-
DDustball replied to the thread Wish I had another inch or so ;).I'll do you one better- I would have wrapped the stack in duct tape.
-
DDustball replied to the thread Hydraulic Deflector not working.87A is the normally closed contact. 87 is the normally open contact. Power for the device (light, motor, etc...) is supplied to...
-
-
DDustball replied to the thread Hydraulic Deflector not working.Summarizing what you've said and what should be checked- For this list, I'm assuming pin 1 is +12VDC and pin 2 is ground. It could be...
-
-
DDustball reacted to Hugo Habicht's post in the thread Recommendations wanted for a Hydraulic Post Hole Digger with
Like.
Flow rate -> speed Pressure -> torque -
DDustball replied to the thread Hydraulic Deflector not working.As others have said, the good news is that function-wise it seems that everything is working. The switch, the relay, and the solenoid on...
