Recent content by dkbswim

I installed the Ratcheting ASSY ROD,LIFT from the B2650 Part # 6C170-65305 on my B2601

I have the hydro and HST ones did not feel the need for the fuel one. good quality, fairly easy install

I had the Titan implements FL-135 now IronCraft it was built by Cosmo in Italy.

don't visit e-trailer

in regards to using it as a tie down Anything 10k or more has to have 4 points of contact. IE , a chain & binder on each corner but if under 10k two is fine. 4 is better but 2 is acceptable. Disclaimer don't take this as legal advice please review laws that apply for you look up CFR title 49...

more importantly were the chains crossed???

KUBOTA Part # 01133-51225 BOLT M12X1.25X25 with lever up should not be spring loaded.

Inside the gearbox, The rear PTO spline are not aligned so they will not mesh up. next time try bumping the PTO clutch on and off with the tractor running. once the Mid PTO stops try changing the PTO selection lever. the same thing can happen with the transmission range selector if it happens...

he was guilty by a default judgment. the facts of the case were not heard. I do not listen to the guy but feel there is a huge miscarriage of justice in this case. he was not Adam Lanza. he did not kill the kids at sandy hook. he is a conspiracy theorist.

the manual has 2014 on it. I'm guessing it is from Europe or Australia. the LX in Europe has the forward angle ROPS

Kubota for the the wiring and hard lines. summit kit for the price and additional features available but its your money i would do the summit rear remote kit and run the add on front kit

https://www.kubotabooks.com/AutoIndex/index.php?dir=Tractor%20Owners%20Manuals/ note loader and tractor are separate items

LX2601 = B2650

B2601