Recent content by bxwoody

  1. B

    NGK glow plug number for 200 BX1800

    Thank You!
  2. B

    NGK glow plug number for 200 BX1800

    Anybody have the NGK part# for glow plugs for 2000 BX1800? And the best place to buy from? I tried the NGK website I did not have much luck. Thanks for the help.
  3. B

    Bx1800 will turnover won't fireup and run

    Final update. Tractor starting normal, running good. Parts fired from parts Cannon include - new Denso fuel injectors ($350) New water pump, Thermostat, and fan belt.
  4. B

    Bx1800 will turnover won't fireup and run

    That is a good suggestion, They are 25 years old.
  5. B

    Bx1800 will turnover won't fireup and run

    I got the new Injectors installed. Did the test to check injection pump, seamed fine. Had a hard time firing up,lot of smoke at first but ran fine. I started it up this morning, 42F in garage. It started right up very little smoke seams normal. When I ran it Yesterday the fan belt came off bad...
  6. B

    Bx1800 will turnover won't fireup and run

    since new 2000. It has 1879hrs. Changed oil every year. When taking line off top of injector very very small amount fuel when tuning over all 3 lines. Have fuel to pump. I ordered new injectors and will remove pump and have rebuilt or replaced.
  7. B

    Bx1800 will turnover won't fireup and run

    Here is a link to my tractor turning over. Preheated with heat gun in intake. Compression is in limit on two cylinders. No oil use or smoke, lack of power before this hard to start then not running at all. the link to video. https://youtu.be/u9rdjFdtb0g
  8. B

    Bx1800 will turnover won't fireup and run

    OK Tomorrow.
  9. B

    Bx1800 will turnover won't fireup and run

    I tried the heat gun on high with rubber intake hose removed. Only black smoke would not fire up. May be back to fuel issue (injectors)? It is not lack of heat from glow plugs. Had the heat gun on high for a couple minutes before turning over.
  10. B

    Bx1800 will turnover won't fireup and run

    Yes, I tested glow plugs with ohm meter. I have heat gun. Will try.
  11. B

    Bx1800 will turnover won't fireup and run

    I loosened each line at the injector one at a time while turning engine over only got small amount of fuel, same on each line. I have 12.2volts at glowplugs when wire is off 10.5 when wire is on glowplugs. The black smoke is back. It tries to hit off and run. Battery is good less than a year...
  12. B

    Bx1800 will turnover won't fireup and run

    Only very small amount of smoke now when turning over.
  13. B

    Bx1800 will turnover won't fireup and run

    I swapped the injectors. Compression test (front) #3 = 280psi #2= 380psi #1 = 340psi. Before swap, #3 was 260psi. Same cylinder that was 260psi before swap. I did the compression test twice to verify. Should I replace the injectors and see what happens? I replaced the two fuel filters and...
  14. B

    Bx1800 will turnover won't fireup and run

    OK, Thank You!
  15. B

    Bx1800 will turnover won't fireup and run

    I believe that is what I will do when I get a free day to work on it. This should answer if it is the injector or maybe the injector pump that feeds that injector. Thanks!
See more
Top Bottom