BXHoosier's latest activity

  • BXHoosier
    BXHoosier replied to the thread Pallet Forks for a BX.
    I made a set of forks that hang over the top lip of the bucket. Then, I built a 3-point frame that the forks fit onto. The frame also...
    • IMG_7839.jpeg
  • BXHoosier
    Wired the mill using a VFD (Variable Frequency Drive) to get 3-phase power. It ran fine but the head was a little noisy. The plastic...
    • IMG_2306.jpeg
    • IMG_2315.jpeg
    • IMG_2316.jpeg
  • BXHoosier
    BXHoosier replied to the thread Temporary bucket mod for snow?.
    Too soon to tell. I only used it for about 5 minutes. My asphalt is fairly smooth so it should easily last through the winter if we get...
  • BXHoosier
    BXHoosier replied to the thread Temporary bucket mod for snow?.
    I bolted a piece of composite decking onto the bucket today and scraped some snow off the driveway. I cut 3/8” deep counterbores and...
    • IMG_2211.jpeg
    • IMG_2208.jpeg
  • BXHoosier
    BXHoosier reacted to Lil Foot's post in the thread Show us your Shop and Equipment with Like Like.
    For an upcoming project, I needed to cut a large (23 3/4") disc from 1/2" UHMW. My ancient Atlas bandsaw was not big enough for the...
  • BXHoosier
    BXHoosier replied to the thread A wish.
    Happy New Year to the gang.
  • BXHoosier
    After years of casually looking for a Bridgeport style knee mill, I finally bought one yesterday. It is a Willis model 1050. It was...
    • IMG_2163.jpeg