BruceP's latest activity

  • BruceP
    A recient RTR subject:
  • BruceP
    BruceP replied to the thread Sticker SHOCK.
    Are you aware that the oil flows from the OUTSIDE to the INSIDE of an oil-filter? (There is more surface-area on the outside to capture...
  • BruceP
    Kinda like asking how long until you sharpen your chainsaw. It depends. If the wood or grass is clean, you don't hit dirt, you can cut...
  • BruceP
    However, the very DEFINITION of "clean" has many viewpoints. One viewpoint suggests that CARBON is a natural element and therefore not...
  • BruceP
    BruceP replied to the thread Bad Ground side effects.
    Press new bearings into the dynamo and it is good for another 10k hours. (I would expect two '2RS' bearings to cost less than $10)
  • BruceP
    The "Right To Repair" conflict goes deeper than who can fix it. Some manufacturers (John Deere...others) do not even release the...
  • BruceP
    BruceP replied to the thread Puter geeks.
    Personally, I would consider the "ad" to be some kind of trojan-horse trying to get into my 'puter. IMMEDIATELY run a security scan on...
  • BruceP
    BruceP replied to the thread Bad Dynamo?.
    What you say above only holds true for AC voltage measured with a "True RMS" meter. Most folks do not have access to such a device...
  • BruceP
    BruceP reacted to lugbolt's post in the thread Bad Dynamo? with Like Like.
    correct but the knowledge is being shared which is important to those that need it
  • BruceP
    BruceP replied to the thread Bad Dynamo?.
    Just a reminder --> THIS DISCUSSION WAS OVER IN 2017 :unsure: :rolleyes:
  • BruceP
    BruceP replied to the thread Bad Ground side effects.
    Have you cleaned the guts of the keyswitch as I described in post #9 ?
  • BruceP
    BruceP replied to the thread Bad Ground side effects.
    This is kind of a 'trick' question. If we define: "Ground" to mean battery minus "Power" to mean Battery plus The answer is "NO"...
  • BruceP
    BruceP replied to the thread Bad Dynamo?.
    Please start a separate discussion regarding this TOTALLY DIFFERENT problem from what this discussion is about. (I know the answer to...
  • BruceP
    NO NO NO!!! testing ohms on a high-current circuit is not the proper way to test. Even a very small resistance can drop large voltage...
  • BruceP
    BruceP replied to the thread Glow Plug Switch Wiring.
    No problem... perhaps I did not explain well enough. Firstly: You need to understand the physical principal that resistance goes UP...