Recent content by bky

  1. B

    L245DT Front Axle Oil Seal?

    thank you wolfman
  2. B

    L245DT Front Axle Oil Seal?

    ok I am in the same situation, what way does the oil seal go I assume spring of the seal towards the inside? Thanks
  3. B

    Saftey Saftey Safety!!!!

    I am far from being a person that spells good, and even worse at grammar but wouldn't it be their and not there? :confused: I think the point is about the safety not the spelling of it.
  4. B

    3 pt. lever wont work properly.

    Thank you wolfman , replacing the spring washers and nuts solved my problem. well worth the 7 dollars and change on parts. but i will tell you the back nut was a pain to remove the threads on the nut were rolled over making it tough to get off. sure will making the 3 point easier.
  5. B

    Recent Site Outage - the good, the bad and the ugly

    Mr. K i have been a member to tbn for a long time. and yes there is a wealth of information there. but at times there are too many post to keep up with. i was with that site when they were a lot smaller and the information was easier to find. but i seem to be spending more time on this...
  6. B

    Recent Site Outage - the good, the bad and the ugly

    I would agree it would be a good idea to weed out the unused members but wouldn't it hurt the advertising. Mr K couldn't say we have x number of members on this site. the actual numbers would be lower than what it is now. isn't it a numbers game?
  7. B

    New to me 3 point tiller

    looks like a Yanmar RS1303 tiller
  8. B

    What is this on my L2201DT?

    If i was to guess the plugs could be removed for hydraulic hoses for a front end loader. It is just a guess though.
  9. B

    Forum time and time zones.

    sounds like time to play the lottery :)
  10. B

    l245dt front wheels

    we need pictures:)
  11. B

    Hydraulics theory and operation

    I just tore into it. if you do watch out for the bearing on the float side so you don't lose them. there is not much to it.
  12. B

    Hydraulics theory and operation

    I have the same setup. with the same amount of hoses. and I believe your loader vale is indeed a open center valve. I and wondering if your loader controls might need rebuilt I know I had to replace o rings in mine. also I had to replace the ball bearing on the left lever to make the float...
  13. B

    purchase

    where in ky are they?
  14. B

    Finally got a Kubota ... got some ??s

    the reservoir takes 90weight ear oil. also check out the front and real axle they take90 weight as well. Nice looking rig you have there.
  15. B

    L245DT medium or light duty pallet forks?

    I would agree light duty would be the way to go. your loader is most probably rated for around 1000 lb but if I were you with little materials welder and time I would recommend making a set where you can take your bucket off and install the forks. It would also put less stress on your bucket...