Recent content by Arkubota

Well $500 later 4 new cylinders my FEL works perfect. Thanks everyone for the help.

Good idea. Thanks.

I have a hydraulic cylinder 1.5 bore and 1” rod part#AC03011300A. Where can I get seal kit and do they make a universal seal kit?? Thanks

Here are the boom cylinders.

Well I took 1 bucket cylinder apart se anything missing?

Yeah you hit the jack pot better grab that parts tractor for sure. And yeah I could of bought a new compact tractor but then I wouldn’t have anything to work on. What’s the fun in that?? 😂

I will do that if I can find enough hoses to reach back to the fill port. Another note I will add is the 1 cylinder that is good I could extend it and retract both ways till it bottom out and it would change the rpms of the engine . The other cylinders would not change the engine rpms.

I had a b6100 with a kubota tiller and bushhog and even a finish mower it was a good tractor. I sold it and bought a b7100 with a 4 way hydraulic front blade the rear pto didn’t work so I rebuilt it which involved bearings and 2 new gears which the gears were hard to find. Bought this front end...

I suggest that you figure out how to get it hooked up on the tractor before you spend time away with cylinder repair. Have you mounted the cylinder and moved the loader as requested? It is hooked up exactly as the diagram was shown. The cylinders are bad they are bypassing and not allowing...

Yes a loader is worth it’s weight in gold. By the way I just want to say this is a awesome forum website. I have googled lots of things on tractors and y’all’s post would come up and I would look at different topics but just the other day I signed up and will probably upgrade to lifetime member...

Well whatever it takes It will be fixed at this point lol too much work invested in it. I’m pretty handy with tools just not well knowledgeable on hydraulics and plumbing so I was thinking of pricing a rebuild kit for the cylinders after I take them apart tomorrow to see how bad they are. The...

The guy I bought the loader from bought it at a auction just for the bucket but couldn’t use it so he never hooked it up but he told me that it was on a yanmar tractor so visual looking at it all looked good. They are all 4 the same length cylinders identical to each other

Well I’m guessing I need to purchase or rebuild cylinders?

Boom cylinder on the right side would cycle in and out but I could move the cyl with my hand in and out by hand and left side cylinder would cycle out but wouldn’t cycle in and I could also move it in and out by hand. In other words I could physically grab the end of the rod on the cylinder and...

So you think my cylinders are good?