Recent content by airborne24

  1. A

    3 pt hitch slow to raise

    dealing with this now too. It used to work from the lower number settings. Have you come across any way to adjust this? several threads indicate it is internal and can't be adjusted. not sure why it changed on my tractor.
  2. A

    3 Point only raises less than halfway

    Why does that change over time? seems like there should be a way to adjust it. it appears to lift all the way again, but because the lift occurs between 5 and i think it goes up to 8. It has a higher sensitivity as the movement happens over a smaller movement. not sure why that would be. If...
  3. A

    3 Point only raises less than halfway

    Was busy with work last week and just got to look at this again over the weekend. Adjusting the nuts 050 on the feedback arm 30 allowed the 3 point to go higher. Thank you so much for pointing me to this. the speed control knob works now too. the remaining issue is that the 3 point doesn't want...
  4. A

    3 Point only raises less than halfway

    It has a land plane grader on it.
  5. A

    3 Point only raises less than halfway

    It was one of the hoses that runs along the side of the loader arms. The loader functions normally. Another symptom i forgot to mention in original post, the speed control knob for the three point doesn't have any effect on 3 point action.
  6. A

    3 Point only raises less than halfway

    I have run it long enough without any improvement in lifting range. Not sure that it will resolve by itself.
  7. A

    3 Point only raises less than halfway

    I have a 2016 B2650. Changed out a leaking hose on the Front end loader. Replaced hydraulic filters and refilled. The tractor HST drives properly, FEL works normally, but the 3 point only goes up less than halfway. Manual says to drive it for awhile to regain the power to the 3 pt lift...
See more
Top Bottom