Recent content by 12251hd

As I have bent or broken a couple tail wheels on my bushhog by backing into something over the years, I'm always cautious of backing into areas where I don't know what is there. Similarly, running over a stump or unseen T post is equally concerning. In those cases I usually lower the bucket...

Ditto on the "check your tires" comment. Once had a BX 1500 where one of the tires spun on the rim. Good luck.

The front driveshaft coupler on my L35 stripped and was easy to replace--held by roller pin. But it made a rumble noise when engaged in 4 WD. Jack up front and make sure that's your problem before tearing into it. I found it easier to remove roller pin first and place in last as you will need...

My 2000 L35 with 2800 hrs has original injectors. You're good to go.

I have an M6800, which has similar setup as yours. Under almost same conditions, I found my ground cable was itself faulty resulting in weak start. Replaced, problem solved. Good luck.

Probably not your problem, but I had to replace the ground cable on my 6800 as ohm meter showed it was faulty with a weak start. Good luck.

Great work on your BH. I have a 2000 L35 LTB. They are great machines. Unfortunately many were used in the renatal business and were abused and left to sit outside. I use a local hose shop for all my hoses--measure and fit. Even though my machine has always been stored inside the shed...

I have a 2006 RTV 900 with 2700 hrs. Bought new. I use it on the farm for utility work and keeping an eye on everything, which includes some steep hills. It goes everywhere I want. I normally drive in mid range around the farm, but put it in low on steep climbs and descents. I'd want to...

I had a local tractor mech replace all of my L35 BH hoses. He found it cheaper and quicker to source hoses locally. Good luck.

If your hoses have been replaced over the past few years, you should be good to go. We had a local hose shop make the BH hoses. With the dipper clynder rebuild, total cost was just over $700, including local mech labor. Recall hose costs from Kubota was much more and availability was also a...

I have a 2000 L35 TLB with 2600 hrs. Always stored inside. Solid machine. Plan on replacing hoses. I had a local mech replace the BH hoses along with a leaking dippler clyninder recently. I had to replace the metal hyd lines coming out of the tranny to the hyd pump and loader valve a couple...

Believe PTO has one.

I have an M6800, which I believe has the same set up as yours. In the heat, my gauge runs between middle and 3/4 when bushhogging. Key is to keep the radiator fins blown out. I have to stop regularly to clean off debris from the hood inlets. Others have reported using a battery pack blower...

Just traded my '13 Silverado 2500HD for a '22 2500HD. High trade-in made the deal.

I replaced both tubes coming from tranny on my L35. I recall only one connected to a hose that went to the loader. The other was a tube going to the pump. Hard area to get leverage to break connections loose. Good luck.