bolt pattern front L345DT

motionclone

Well-known member
Lifetime Member

Equipment
L345DT with Lp mower, forks and grapple thumb, Bobcat 337 Midi Ex
May 4, 2018
1,398
992
113
Maine
Can anyone tell me what the bolt pattern is for the front rims on an L345DT. Ive looked and cant find that info. Im wanting to buy 2" wheel spacers
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,286
4,853
113
Sandpoint, ID
Can anyone tell me what the bolt pattern is for the front rims on an L345DT. Ive looked and cant find that info. Im wanting to buy 2" wheel spacers
You DO NOT use spacers on the front, all that will do is cause you a ton of grief!

Now why would you even want to do that?
 

motionclone

Well-known member
Lifetime Member

Equipment
L345DT with Lp mower, forks and grapple thumb, Bobcat 337 Midi Ex
May 4, 2018
1,398
992
113
Maine
I have a special circumstance and need wheel spacers or cut out the centers and reweld. Spacers will allow me to put my wheelbase closer to stock.

Plan would be to flip the wheels left to right then add 2" spacers like you suggested in a thread of mine:

...The issue is that you have an aftermarket loader that wasn't exactly made for that model tractor.

My suggestion would be to flip the rims and figure out how much offset you need and figure out either different rims or wheel spacers to keep it as close to the inside as you can to reduce stress on the front axle. ;)....
http://www.orangetractortalks.com/forums/showthread.php?t=36173&page-2
 
Last edited:

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,286
4,853
113
Sandpoint, ID

JNb

New member

Equipment
L3000DT
Dec 1, 2018
11
0
1
New brunswick
6 bolt, 152.4mm (6"), 117.4mm (4.622")centre hole, 14mm wheel bolts. Does that sound right?
 
Last edited:

motionclone

Well-known member
Lifetime Member

Equipment
L345DT with Lp mower, forks and grapple thumb, Bobcat 337 Midi Ex
May 4, 2018
1,398
992
113
Maine
OK, So I read up on the proper way to measure (according to the interwebs) and I come up with 6 on 6"

I measured inside of one stud to outside of the opposite stud and got 6" exactly
 

motionclone

Well-known member
Lifetime Member

Equipment
L345DT with Lp mower, forks and grapple thumb, Bobcat 337 Midi Ex
May 4, 2018
1,398
992
113
Maine