Loose controls to raise/lower hydraulics

T

the engineers

New member

Equipment
B6200HSTD, Westendorf TA-55 FEL
Jul 15, 2014
14
0
0
Lincoln, NE
I have a B6200HST. The lever to raise or lower the deck and 3-point is vague at best and requires almost zero effort to actuate. I've accidentally raised the deck by bumping it when turning a corner.

Is there a way to firm this up?

Also, should the lever self-center? When I raise/lower, I have to put the lever back to center or it leaves the hydraulic hoses under pressure at all times.
 
North Idaho Wolfman

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,664
5,097
113
Sandpoint, ID
#1 Yes there is a way to tighten up the three point control.
In the picture tighten the (510) nut to put more force on the 2 tension washers (390), if it won't tighten you will need to replace some parts. ;)

#2 No there is no way to make it a center off valve.
What hoses? The three point has no hoses the control it? :confused:

 

Attachments

T

the engineers

New member

Equipment
B6200HSTD, Westendorf TA-55 FEL
Jul 15, 2014
14
0
0
Lincoln, NE
Sorry, I have accessory hoses for a FEL set-up. I can watch those to see when they're under pressure.

Assuming it won't tighten, which parts need replaced?
 
Last edited:
You must log in or register to reply here.

Top Bottom