Z650 decompression adjustment

baggy

New member

Equipment
Woodmizer with Kubota Z650
Sep 1, 2017
5
0
0
Bella Coola BC Canada
Hi Folks,
Newbie here trying to find info on decompression lever adjustment on a Z650 engine. I recently installed the Kubota on my woodmizer bandsaw mill but it is very hard to turn over even with good batteries and decent cold cranking amp ratings on a warm summers day (all battery connections are clean and solid). Nothing happens when the levers are actuated in terms of speed of engine turning over. Once the engine has warmed up it starts every time on 2nd revolution, but slow to turn over.
The attached pics show the 2 levers that go down through the valve cover.
Great site!! :)

[/ATTACH]
 

Attachments

Last edited:

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,306
4,856
113
Sandpoint, ID
sorry have not seen that decompression setup, but if you pull the valve cover take a few pics of it and we should be able to help you sort it out. ;)