Can anyone tell me what has to be done to pull the rear axle on an L175 to change the seal?
Thanks....
Thanks....
L175 rear axle seal replacement
- Thread starter steveny
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Not that big or bad of a job, just need to unbolt the case and remove the axle.
The WSM will tell you all the steps.
The WSM will tell you all the steps.
kubotafreak
Well-known member
Equipment
GRAND l6060, L3560, B6100, gr2100, tg 1860, g1800, g1900, g2160
Workshop service manual. That bell shaped axle housing must be removed. Then inside you will find a configuration of retainers to keep the axle shaft restrained. The end bearing may or may not have a bolt on seal/bearing flange. Pretty self evident when you do it. Mind you will need to drain some or all of the hydraulic fluid.
Last edited:
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more