Tie rod is bent and needs to be replaced. Is this a simple procedure or is there something I need to be concerned about?
Replacing Tie Rod in B7500
- Thread starter rogler
- Start date
Wild and Free
New member
Equipment
B2150 HSD w/Case L340 fel 68" quicktach bkt, 60" jinma snowblower, box scraper
How bad is it bent? If not bad I would straighten best one can and there would be enough adjustment to get toe in really close.
It was pretty bad. I was able to get it bent back but it does seem like it is still toe-in too much. Maybe if I can get it off I can bend it some more.